User manual PANASONIC AJ-D400

[. . . ] This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CAUTION: To reduce the risk of fire or shock hazard and annoying interference, use the recommended accessories only. is the safety information. Do not insert fingers or any objects into the video cassette holder. [. . . ] With assemble editing, the ASSEMBLE lamp light. With insert editing, press the button of the channel whose signals are to be edited and light its lamp. Select the VTR to be operated (this setting is performed when editing with 2 VTRs). Press the PLAYER or RECORDER button to select the VTR. PLAYER: Press this button to operate the player VTR and enter the edit points. RECORDER: Press this button to operate the recorder VTR (this unit) and enter the edit points. 1, 2 3 -33- Automatic editing Entering the edit points Search for the edit IN point by performing the jog or shuttle operation. Establish the still picture mode at the desired position. Refer to page 28 for details on the jog/shuttle operations. The edit IN point value now appears on the display. Search for the edit OUT point by performing the jog or shuttle operation. Establish the still picture mode at the desired position. When the edit OUT point is reached, the unit automatically goes into the stop mode. 1 -37- Automatic editing Executing automatic editing Press the AUTO EDIT button. To stop the editing at any time, press the STOP button. When the edit OUT point is reached, the unit goes into the stop mode after postrolling. Postroll With assemble editing, editing continues for approx. 2 seconds even after the edit OUT point has been passed, the tape is rewound to the OUT point, and the unit goes into the stop mode. With insert editing, the unit goes into the play mode after the edit OUT point has been passed, the tape is rewound to the OUT point, and the unit goes into the stop mode. Retry function If the AUTO EDIT button is pressed again after the STOP button has been pressed to stop the editing, editing will start again from the beginning. Auto tag editing If the AUTO EDIT button is pressed when the next edit point has not yet been entered upon completion of editing, the previous edit OUT point will be entered as the IN point, and editing is performed accordingly. To release the auto tag mode, press one of the tape transport buttons (PLAY, etc. ). <Note> The entered points are automatically cleared after editing is executed. However, the previous editing points can be recalled by pressing the TRIM+ (or TRIM­) and SET buttons together. 1 -38- Review Upon completion of the editing, press the REVIEW button. [. . . ] 4 5 6 RECEIVE COMMON Signal TRANSMIT COMMON Pin No. 7 8 9 Signal RECEIVE B TRANSMIT A FRAME GROUND - 67 - Connector signals PARALLEL REMOTE (25P) Pin No. 1 2 3 4 5 6 7 8 9 Signal PLAY COMMAND STOP COMMAND FF COMMAND REW COMMAND REC COMMAND EJECT COMMAND STANDBYON/OFFCOMMAND PREROLL COMMAND IN SET COMMAND Pin No. 10 11 12 13 14 15 16 17 18 > 10V, MAX 300mA PLAY STATUS STOP STATUS FF STATUS REW STATUS REC STATUS EJECT STATUS Signal Pin No. [. . . ]