User manual PANASONIC AJ-D90P

[. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Use of another battery may present a risk of fire or explosion. [. . . ] 2) To increase the normal analog gain (in which case, the amount of noise will increase) Use only the S. GAIN function. 3) To use the unit in the ultra-high-sensitivity mode Use the S. GAIN function and DS. GAIN function in combination. (This enables an increase in gain of up to 68 dB. ) However, caution should be observed since the higher the DS. GAIN increase, the more noticeable the after image becomes with moving subjects. Use a gain increase of up to +12 dB : with moving subjects. The DS. GAIN function does not work when the unit is used in the progressive mode. #< USER SW GAIN > S. GAIN ¢30dB ¢36dB ¢42dB ¢48dB DS. GAIN ¢ 6dB ¢12dB ¢20dB f f f The signals which are output from the VIDEO OUT connector and MON OUT connector can be selected. To select this function, perform menu operations to open the <OUTPUT SEL> screen from the SYSTEM SETTING page, select the VIDEO OUT signal for the VIDEO OUT SEL item, select the type of characters to be superimposed onto the VIDEO OUT signal and MONITOR OUT signal for the OUTPUT CHAR item and MONITOR OUT CHAR item, and select whether or not the characters are to be superimposed onto the MONITOR OUT signal. When the AJ-A902G expansion board is installed, the SDI OUT signal can be output as the signal selected as the VIDEO OUT signal. #< OUTPUT SEL > VIDEO OUT SEL OUTPUT CHAR MONITOR OUT CHAR VF MODE :VBS :MENU ONLY :OFF :EE/PB 4 Setting items and details Item VIDEO OUT SEL Variable range VBS VF Y SDI Remarks For selecting the output signal of the VIDEO OUT connector. VBS: The normal composite signal is output. VF: The viewfinder's Y signal is output. The status display is also superimposed. SDI: This item can be selected only when the AJ-A902G expansion board has been installed, in which case the SDI signal is output. The IRIS override function is allocated. This changes the target (reference) value in the auto iris mode. To change the target value, first establish this mode, and then press the JOG dial button to enable the target value to be changed. The target value is changed by turning the JOG dial button clockwise or counterclockwise. "+, " "+ +, " "­" or "­ ­" is displayed on the left of the iris display area on the viewfinder screen. Stop turning the JOG dial button at the position to be changed, and press the JOG dial button to enter the change in the target value. The reference value is restored when this mode is released or the power is turned off. +: The aperture is opened by a half stop. + +: The aperture is opened by a full stop. ­: The aperture is stopped down by a half stop. ­ ­: The aperture is stopped down by a full stop. [. . . ] The CAMERA ID settings for VF INDICATOR1 are used. For selecting whether to use the VITC UB for a purpose other than the frame rate when the camera is operated in the 24P or 24PA mode. MENU: Operations that comply with the VITC UB MODE item setting are allowed. <Note> When the camera is operated in a mode other than 24P or 24PA, the setting selected for the VITC UB MODE item on the <TC UB> screen is complied with regardless of what has been selected as the 24P VITC UB item setting. UMID SET/INFO Variable range NO-INFO NO-INFO Remarks For inputting the name of the user's country. [. . . ]