User manual PANASONIC AJ-HD2700P

[. . . ] For your safety, if in any doubt about the effective grounding of the equipment or power outlet, please consult a qualified electrician. CAUTIONS: In order to maintain adequate ventilation, do not install or place this unit in a bookcase, built-in cabinet or any other confined space. To prevent risk of electric shock or fire hazard due to overheating, ensure that curtains and any other materials do not obstruct the ventilation. CAUTIONS: TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD AND ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY. CAUTION: THE AC RECEPTACLE (MAINS SOCKET OUTLET) SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. TO COMPLETELY DISCONNECT THIS EQUIPMENT FROM THE AC MAINS, DISCONNECT THE POWER CORD PLUG FROM THE AC RECEPTACLE. WARNING: TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD, KEEP THIS EQUIPMENT AWAY FROM ALL LIQUIDS. [. . . ] If this signal is not available, the unit's internal reference is used. 0002 HD REF : The HD REF input signal serves as the reference. If this signal is not available, the unit's internal reference is used. 0003 SD REF : The SD REF input signal serves as the reference. If this signal is not available, the unit's internal reference is used. 0004 E-AUTO : When the editing mode is selected, the state is the same as when set to "INPUT. " When any mode other than the editing mode is selected, the state is the same as when set to "AUTO. " For details, refer to "Reference signals" (page 16). Select the reference to synchronize the image frames for recording. 0000 NORMAL : The video signal which is input is automatically identified and serves as the reference. 0001 SLTC : The time code which is input to the HD SDI IN connector isidentified and serves as the reference. <Note> When the SLTC is selected, the following settings are necessary to validate the settings for this item. 020 SYS FORMAT: 720p INPUT SELECT button on the front panel: HDSDI AUTO <Notes> When the tape is ejected, the format follows the one selected by menu item No. 020 SYS FORMAT setting. EE: The signals are output in the EE mode. TAPE: BLACK is output for the video, and the audio is muted. 0002 GRAY : The output status differs according to the setting of the menu No. 140 OUTPUT. EE: The signals are output in the EE mode. TAPE: GRAY is output for the video, and the audio is muted. <Note> When "23/24" mode, "25 (HD/SD)" mode, or "50 (HD/ SD)" mode is selected in menu No. 25 SYSTEM FREQ, BLACK is output if "EE" is selected. 108 For setting the play rise time in frame increments. 0 PLAY DELAY 0000 : : 0015 15 109*1 CAP. LOCK For selecting in how many field increments the playback framing is to be locked. 0000 2F 0001 4F 0002 8F <Notes> "8F" can be selected only when "50i/25p" is selected as the menu item No. 25 SYSTEM FREQ setting. In the HD LP or HD SP mode, 2F mode is selected when recording and playing back, including editing, regardless of the menu. [. . . ] If the take-up reel motor has rotated in the reverse direction, this error number flashes on the display. Set the POWER switch to OFF STOP and then to ON again. Set the POWER switch to OFF STOP and then to ON again. Set the POWER switch to OFF STOP and then to ON again. If excess torque being applied to the cylinder motor is detected, this Set the POWER switch to OFF STOP error number flashes on the display. [. . . ]