User manual PANASONIC AJ-D220P

[. . . ] This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CAUTION: To reduce the risk of fire or shock hazard and annoying interference, use the recommended accessories only. THIS APPARATUS MUST BE EARTHED To ensure safe operation the three-pin plug must be inserted only into a standard three-pin power point which is effectively earthed through the normal house-hold wiring. [. . . ] 0: EE mode 1: Playback mode <Note> This setting is complied with even in the standby OFF mode. However, the images will appear in gray when "TAPE" has been selected. This selects whether to rewind the tape automatically to the tape start when the tape end is detected. 1: The tape is rewound to the tape start. 109 EJECT EE SEL 110 F/R EE SEL 0000 0001 EE TAPE 111 STOP EE SEL 0000 0001 EE TAPE 112 AUTO REW 0000 0001 OFF ON The underline on the setting item denotes the initial setting. 24 USER menu <OPERATION> (continued) Item No. 113 Superimposed display MEMORY STOP No. 0000 0001 Setting Superimposed display OFF ON Description This selects whether the VTR is to stop automatically when the counter value reaches "0" during a fast forwarding or rewinding operation in the CTL mode. The stop mode concerned is either the stop or the stillpicture mode depending on the setup menu No. When both the AUTO REW function and MEMORY function have been selected at the same time, the AUTO REW function takes precedence. This selects whether to allow (enable) or prohibit (disable) the recording of signals on the cassette tape. 0: Signals can be recorded on the cassette tape when the cassette's accidental erasure prevention mechanism is set to the recording enable position. 1: Recording on the cassette tape is prohibited. 0: Standard/non-standard signals are automatically identified and processed. (Forced STD) 2: Non-standard signals are processed. (Forced NON-STD) This selects the video signal processing. 0: Servo is synchronized with the input signal during recording and editing, or with the REF signal during playback. 1: Servo is synchronized at all times with the REF signal. This sets the channel assignments for the controller's analog audio preset when editing the digital audio of the VTR using a controller which does not have a digital audio edit preset control function. This selects the channel concerned when the VTR CH1 edit preset is set in compliance with the ON or OFF presetting for the analog audio signals designated by the controller. 1: Compliance with analog CH1 edit preset. 2: Compliance with analog CH2 edit preset. 3: Compliance with either analog CH1 or CH2 edit preset. This sets the channel assignments for the controller's analog audio preset when editing the digital audio of the VTR using a controller which does not have a digital audio edit preset control function. [. . . ] display flashes, and the unit goes into EJECT mode. The drum rotates after the cassette tape is ejected to remove condensation. When the condensation has been removed, the error no. display disappears and the VTR may be used. [. . . ]