User manual PANASONIC AJ-D900W

[. . . ] Extension cords used with the equipment must have three cores and be correctly wired to provide connection to the ground. Wrongly wired extension cords are a major cause of fatalities. The fact that the equipment operates satisfactorily does not imply that the power outlet is grounded or that the installation is completely safe. For your safety, if you are in any doubt about the effective grounding of the power outlet, please consult a qualified electrician. [. . . ] 112 V IN SEL INH This selects whether video input switching using the INPUT SELECT button is to be enabled or disabled. 0000 OFF : Video input switching using the INPUT SELECT button is enabled. 0001 ON : Video input switching using the INPUT SELECT button is disabled. 0002 REC : Video input switching using the INPUT SELECT button after the unit has been transferred to a recording (but not editing) mode is disabled. 113 This selects whether audio input switching using the INPUT SELECT button is to be enabled or disabled. 0000 OFF : Audio input switching using the INPUT SELECT button is enabled. 0001 ON : Audio input switching using the INPUT SELECT button is disabled. 0002 REC : Audio input switching using the INPUT SELECT button after the unit has been transferred to a recording (but not editing) mode is disabled. <Note> Even when the ON or REC setting is selected to disable audio input switching using the INPUT SELECT button, it is still possible to set the setup menu items No. 720 (D IN SEL34). This selects whether to rewind the tape automatically to the tape start when the tape end is detected. 0000 0001 OFF : The tape stops at the tape end. These settings are for selecting whether the ACK code is to be returned when a command is received from RS-232C. 0000 0001 OFF : ACK code is not returned. Description These settings are for selecting the none, odd or even for the RS-232C parity bit. This selects whether two or more VTRs are to be operated in synchronization. This sets the ID information to be returned to the controller. For selecting the method used to detect the STANDBY COMMAND signal input at the 25P STBY CMD PARALLEL (25P) connector. 0000 OFF/ON : Each time active signals are detected, the STANDBY ON or STANDBY OFF mode is selected alternately. 0001 ON : When active signals are detected in the STANDBY OFF mode, the unit is transferred to the STANDBY ON mode. Nothing happens if they are detected during an operation in the STANDBY ON mode. This selects whether the PARALLEL (25P) connector is to function when the REMOTE button is set to the local mode (REMOTE lamp OFF). 0000 0001 212 OFF : Connector does not function. ON : Connector functions. This selects whether the RS-232C connector is to function when the REMOTE button is set to the remote mode (REMOTE lamp ON). 0000 0001 OFF : Connector does not function. ON : Connector functions. 205 BAUD RATE These settings are for selecting the RS-232C communication speed (baud rate). [. . . ] The maximum tape speed differs according to the setting selected for setup menu No. REC [STX] ORC [ETX] 4 5 [STX] ORC [ETX] This is the reverse direction shuttle command. data = n : speed data 0 : STILL 1 : a0. 03 2 : a0. 1 3 : a0. 2 4 : a0. 43 (a0. 5) 5 : a1 6 : a1. 85 7 : a4. 1 (a3. 1) 8 : a9. 5 9 : a16 A : a32 <Notes> OThe a16 anda32 speed differ according to the setting selected for setup menu No. OThe value for the DV/DVCAM tape is shown in parenthesis ( ). [. . . ]