User manual PANASONIC AJ-LT85

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. RB RC RBR C Ni-Cd ATTENTION: The product you have purchased is powered by a nickel cadmium battery which is recyclable. At the end of it's useful life, under various state and local laws, it is illegal to dispose of this battery into your municipal waste stream. [. . . ] Please call 1-800-8-BATTERY for information on how to recycle this battery. indicates safety information. 3 Contents Models Supported . 7 Models Supported Camera recorders O AJ-D910WA, AJ-D900W, AJ-D900WA AJ-PD900W, AJ-PD900WA Specifications Power supply: DC 12 V (11 V­17 V) Power consumption: 7 W (including the optional board) Ambient operating temperature: 0°C to +40°C Storage temperature: ­20°C to +60°C Ambient operating humidity: Less than 85% (relative humidity) Audio sampling frequency: 48 kHz (synchronized with video) Audio quantizing: 16 bits 4 Parts and Their Functions 12 4 AUDIO SELECT CH 3/CH 4 (audio channel 3/4 automatic/manual level adjustment selector) switch This is used to select the method for adjusting the audio channel 3 and/or 4 recording level. AUTO : The recording level is adjusted automatically. MAN : The recording level is adjusted manually. 5 AUDIO IN CH 3/CH 4 (audio input selector) switches These are used to select the input signals which are to be recorded on audio channels 3 and 4. MIC : The audio signals from the mic input are recorded. LINE : The audio signals which are input from the audio component are recorded. 8 PHONES (headphones) jack Stereo mini jack 9 PHONES LEVEL (headphones output level adjustment) control This is used to adjust the level of the audio output from the PHONES jack. : AUDIO IN CH 3/CH 4 (audio input channel 3/4) connectors (XLR, 3-pin) The audio component or microphones are connected to these connectors. XLR, 3-pin, female LINE/MIC switching type LINE : +4 dBu (can be changed to 0 dBu using internal switch) MIC : ­60 dBu (can be changed to ­40 dBu using internal switch) Phantom power supplies supported. XLR, 4-pin, male DC 12 V (DC 11 V­17 V) Operating Cautions O Set the EMPHASIS item of the audio menu of the camera unit to OFF before use. O Please consult your local dealer or service center when changing the settings of the switches or VR inside the unit. 6 Attachment to Camera O Consult with your dealer or a Panasonic Service Center representative before attaching this camera adapter. O Take care not to make direct contact with the connector pins. 1 Remove the battery mount from the camera. Battery mount Screws 2 Connect the connectors on the camera adapter to the connectors on the camera unit. <Notes> O Take care to avoid damaging the flexible board during the attachment procedure. O Take care to avoid pinching the connector cords during the attachment procedure. 7 Attachment to Camera 3 Use the 4 screws packed with the camera adapter to screw the camera adapter onto the camera. (M4a12mm) (M4a16mm) 4 Connect the connectors on the battery mount to the connectors on the camera adapter. [. . . ] O Take care not to make direct contact with the connector pins. 1 Remove the battery mount from the camera. Battery mount Screws 2 Connect the connectors on the camera adapter to the connectors on the camera unit. <Notes> O Take care to avoid damaging the flexible board during the attachment procedure. O Take care to avoid pinching the connector cords during the attachment procedure. 7 Attachment to Camera 3 Use the 4 screws packed with the camera adapter to screw the camera adapter onto the camera. (M4a12mm) (M4a16mm) 4 Connect the connectors on the battery mount to the connectors on the camera adapter. <Note> Take care to avoid pinching the connector cords during the attachment procedure. 5 Use the screws to screw the battery mount onto the camera adapter. 8 PANASONIC BROADCAST & TELEVISION SYSTEMS COMPANY DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA Executive Office: 3330 Cahuenga Blvd W. , Los Angeles, CA 90068 (323) 436-3500 EASTERN ZONE: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7621 Southeast Region: 1225 Northbrook Parkway, Ste 1-160, Suwanee, GA 30024 (770) 338-6835 Central Region: 1707 N Randall Road E1-C-1, Elgin, IL 60123 (847) 468-5200 WESTERN ZONE: 3330 Cahuenga Blvd W. , Los Angeles, CA 90068 (323) 436-3500 Government Marketing Department: 52 West Gude Drive, Rockville, MD 20850 (301) 738-3840 Broadcast PARTS INFORMATION & ORDERING: 9:00 a. m. [. . . ]