User manual PANASONIC AL-TA10U

[. . . ] € During operation, HEAT and COOL modes cannot activate at the same time for different indoor units. € The power indicator blinks to indicate the indoor unit is standing by for a different operation mode. outdoor unit (AL-TA10U , CU-2RE18PBE) 2 F568939_YS0912-0. Indb 2 11/23/2012 3:51:43 PM Quick guide Table of contents Inserting the batteries 1 3 2 1 Pull out the back cover of remote control 2 Insert AAA or R03 batteries (can be used ~ 1 year) 3 Close the cover 2 TIMER ON 1 2 SET 3 Safety precautions . [. . . ] € The fan does not stop even if the operation is stopped. Contact your local dealer immediately for maintenance/repair. This equipment must be earthed to prevent electrical shock or fire. Prevent electric shock by switching off the power supply and unplug: - Before cleaning or servicing, - When extended non-use, or - During abnormally strong lightning activity. Do not use for preservation of precise equipment, food, animals, plants, artwork or other objects. this may cause quality deterioration , etc. Do not use any combustible equipment in front of the airflow outlet to avoid fire propagation. do not expose plants or pet directly to airflow to avoid injury , etc. Do not touch the sharp aluminium fin, sharp parts may cause injury. Do not switch ON the indoor unit when waxing the floor. After waxing, aerate the room properly before operating the unit. € To use in HEAT mode, press and hold the button until 1 beep is heard, then release. And press again until 2 beeps, then release. Indb 6 11/23/2012 3:51:48 PM FAN SPEED To select fan speed To set the timer To turn ON or OFF the unit at a preset time. 1 2 3 SET 2 3 (Remote control display) • For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. TIMER ON 1 OFF CANCEL AC C AIR SWING To adjust vertical airflow direction 1 Select ON or OFF timer Example: OFF at 22:00 OFF (Remote control display) 2 Set the time • Keeps the room ventilated. • In COOL/DRY mode , if AUTO is set , the louver swings up/down automatically. € In HEAT mode, if AUTO is set, the horizontal louver is fixed at the predetermined position. 2 3 Confirm SET TIMER • To cancel ON or OFF timer , press or OFF then press CANCEL. € If timer is cancelled manually or due to power failure, you can restore the previous setting SET (once power is resumed) by pressing . € When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time. € Timer operation is based on the clock set in the remote control and repeats daily once set. [. . . ] Close it securely 3 Press both ends of the front panel 1 Insert at both sides • Clean the filter whenever necessary. € Wash/rinse the filter gently with water to avoid damage to the filter. € Dry the filter thoroughly under the shade, away from fire or direct sunlight. € Replace the filter every 10 years or replace any damaged filter. [. . . ]