User manual PANASONIC AW-E300

[. . . ] This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] Horizontal phase cannot be adjusted if the switch is in the CAM position. After adjustment set BAR/CAM switch back to CAM. · When horizontal phase adjustment is moved, color phase is also moved. Adjust color phase whenever horizontal phase adjustment is moved. U Color phase adjustment Supply the output signal (split color bar) from the color special effect generator to a color monitor or vectorscope. Perform fine adjustment with the YES/ABC switch and the NO/BAR switch. Color bar of camera Sprit line Color bar of special effects generator [ADJUSTMENT with RCU (RCB, Hybrid control panel)] Use the subcarrier phase coarse adjustment control and subcarrier phase fine control. It is recommended that a vectorscope be used for maximum accuracy in color phase adjustment. Caution: · When color phase adjustment is required using RCU (RCB) or hybrid control panel, BAR/CAM switch should be set to BAR. Color phase cannot be adjusted if the switch is in the CAM position. After adjustment set BAR/CAM switch back to CAM. · When horizontal phase adjustment is moved, color phase is also moved. · They can be set from the camera and RCU (RCB). They can also be set from the hybrid control panel using the switches, but the setting items are limited because the menu is not shown. Notes: · Composite signals are output from the video output regardless of the position ENC/VF of the RCU (RCB) user set switch. · [End] is displayed only in setting from the camera alone. · [Option Card1] is shown only when an optional card is inserted into the camera. [Option Card2] is shown only when an additional card box is equipped with the camera and then an optional card is inserted into the camera. U Main menu screen Main menu of Halogen, Fluorescent, Outdoor Mode Use mode Blinking Main menu of User Mode -31- Menu item setting If the output signal from camera is color bar, only "G/L, Color Bar Set" screen is displayed. Select [Return] using the MENU switch and ITEM/AWC switch, then press the YES/ABC switch to return to the main menu. After changing the settings, take the following steps. Camera alone: Select [End] using the MENU switch and ITEM/AWC switch and press the YES/ABC switch. RCU (RCB): Set the user set switch in the pocket to the OFF position. [. . . ] A safety zone is not displayed when "OFF" is selected. The safety zone and center marker indicate electrical positions and, as such, they may be at variance with their optical positions. 1 2 3 4 5 1. Zebra Indicator Setting [Zebra: OFF, ON] This is used to select whether to display the zebra pattern on the viewfinder. OFF: The zebra pattern is not displayed on the viewfinder. [. . . ]