User manual PANASONIC AW-PS600P

[. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (service) instructions in the literature accompanying the appliance. CAUTION: Do not install or place this unit in a bookcase, built-in cabinet or any other confined space in order to maintain adequate ventilation. [. . . ] Before installing the optional card, set the power switches of the components to the OFF position, and disconnect the power cords from the power outlets. Remove the two screws, followed by the blank panel. Align the optional card with the guides and insert it. Attach the card securely using the two screws. To remove the optional card, insert a flat-head screwdriver or similar tool as shown in the figure on the right, and pull out the card in the direction shown by the arrow. Slot for optional card 41 Attaching the rack mounting adapters To install the main unit in a rack, use the rack mounting adapters and mounting screws (M4a8 mm) supplied. Replacement of consumable parts O Battery replacement The battery has a life of 5 years. Setting data such as that for the menu settings and tracing memories is stored in the main unit of the MultiFunction Controller. This data is saved when the power is turned off under normal conditions; however, it will be lost if the power is turned off after the battery is exhausted. Refer replacement of the battery to qualified service personnel. O Joystick replacement The joystick is a consumable part. Replace the joystick if operation is impeded. Refer replacement of the joystick to qualified service personnel 42 Specifications [GENERAL] Power supply: DC 10. 8 V to DC 16 V Power consumption: 14. 0 W [MAIN UNIT] $ Input connectors DC 12V IN socket XLR, 4 pins CONTROL IN TO CONTROL PANEL [1, 2, 3] connectors RJ45 a3 Connecting cable: 10BaseT straight cables (UTP category 5), max. 3, 280 feet (1, 000 meters) When more than one control panel is to be connected to the main unit, make sure that the total length of all the cables does not exceed 3, 280 feet (1, 000 meters). . 29 Réglage de l'équilibre des noirs . . 30 Réglage de la mémoire tracé . . 31 Réglage de la mémoire préréglage . . 36 Installation de plaques vidéo additionnelles . . 41 Insertion d'une plaque vendue séparément . . 41 Fixation des adaptateurs de montage en baie . . 42 Remplacement des pièces consommables . . 43 Introduction O Ce coordonnateur multi-fonctions permet de piloter un ou plusieurs systèmes de tête panoramique (composés chacun d'une tête panoramique et d'une caméra convertible) tout en fournissant une compensation pour le câble de signal vidéo. Il se compose d'un appareil principal qui traite les signaux et d'un panneau de commande pour le pilotage du ou des systèmes de tête panoramique, ces deux éléments étant raccordés à l'aide du câble de raccordement (10 m) fourni. O Il est possible de raccorder un maximum de trois panneaux de commande à l'appareil principal. Le raccordement s'effectue à l'aide du câble fourni avec le panneau de commande et d'un câble droit 10BaseT (UTP, catégorie 5). [. . . ] Toutefois, la répétabilité avec la tête panoramique AWPH350 étant de ±10´, il y aura une légère baisse de précision d'arrêt. DIAGONAL SPEED (1 à 30) Cette rubrique permet de sélectionner la vitesse à laquelle le système de tête panoramique doit fonctionner lorsque la rubrique DIAGONAL MOTION est validée (ON). Plus la valeur est élevée, plus la vitesse à laquelle la tête panoramique fonctionne est grande. Si la rubrique DIAGONAL MOTION est invalidée (OFF), il n'est pas possible de régler la vitesse de fonctionnement. [. . . ]