User manual PANASONIC BB-HCM331A

[. . . ] Operating Instructions Network Camera Model No. Outdoor Ready BB-HCM331A Please read this manual before using and save this manual for future reference. Panasonic Network Camera Website: http://www. panasonic. com/netcam for customers in the USA or Puerto Rico Operating Instructions Main Features Splash Resistant body for indoor and outdoor use Your Panasonic Network Camera has a splash resistant body. The splash resistant body allows the camera to be used indoors or outdoors. IPv6*1 Network Camera Your Panasonic Network Camera supports IPv6 (Internet Protocol Version 6), IPv6 was created to address the additional IP addresses that will be needed as the Internet continues to expand. [. . . ] Click [Your Account Link]. 60 Operating Instructions Notes · When the Viewnetcam. com registration website is not displayed, confirm that the URL is displayed in the right column of the Your Account Link. If the URL is not displayed, follow the procedures below. Wait for a while, and click [Refresh] on the web browser. Confirm that your network (your PC and camera) is connected to the Internet. · · Personal (Camera) URL is available after you registered with the Viewnetcam. com service. If port forwarding is not enabled or your network is not connected to the Internet, the Viewnetcam. com service is not available. When the Top page is displayed, the Viewnetcam. com registration is complete. 6. Register with the Viewnetcam. com service following the website. · · 7. Access the camera with a registered URL from the Internet (see page 12). Notes · · It may take a maximum of 30 minutes for the registered URL to work. If "Expired" is displayed at the Personal (Camera) URL on the Viewnetcam. com page or at the Camera URL in the DDNS on the Status page, restart the camera. After that, confirm that your registered URL is displayed on their pages. [For assistance, please call: 1-800-272-7033] 61 Operating Instructions 2. 9 Setting Date and Time The Date and Time page allows you to set date and time. Date and time are used for image buffer/transfer, operation time and time stamps on the buffered image. Note Saving the date and time settings deletes all buffered images on the internal memory. The buffered images on the SD memory card are not deleted. 1. Click [Date and Time] on the Setup page. Set each parameter. · Clicking [Cancel] cancels your settings without saving changes. 62 Operating Instructions Setting Time Setting · Description Select date and format (AM/PM or 24 H). These settings are used for image buffer/transfer, operation time and time stamps on the buffered image. But E-mail subject and file name by E-mail or FTP transfer uses only 24 h format. NTP (Network Time Protocol) server synchronizes the camera's internal clock. In IPv4, set 4 digits (0-- 255) and 3 periods such as "192. 168. 0. 253". But "0. 0. 0. 0" and "255. 255. 255. 255" are not available. In IPv6, set 8 hexadecimal digits divided with ":". Consecutive 0s can be abbreviated as "::". [. . . ] Proxy settings are not required. [For assistance, please call: 1-800-272-7033] 137 Operating Instructions 5. Enter the camera IP address into the Do not use proxy server for addresses beginning with data field. 6. Click [OK]. 138 Operating Instructions 3. 10. 2 Setting UPnPTM to Display Camera Shortcut in My Network Places To display the camera shortcut in the My Network Places folder, Windows component should be added. Enable UPnPTM (Universal Plug and Play) following the steps below. [. . . ]