User manual PANASONIC BT-LH900P

[. . . ] Liquid Crystal Video Monitor BT-LH900P POWER INPUT MENU EXIT HD ZOOM BLUE FUNCTION ENTER PEAK/PHASE CHROMA BRIGHT CONTRAST Before attempting to connect, operate or adjust this product, please read these instructions completely. For your safety CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER TO SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (service) instructions in the literature accompanying the appliance. FCC Note: This device complies with Part 15 of the FCC Rules. To assure continued compliance follow the attached installation instructions and do not make any unauthorized modifications. [. . . ] This item enables two settings, one for the VIDEO input signals and one for other signals, to be stored in the memory. <Notes> While this item's setting is selected, the only information displayed on the screen is this item which appears at the bottom left regardless of the MENU POSI setting selected on the OSD screen. The sharpness can be set for VIDEO and all other input channels. For setting the image sharpness in the vertical direction. This item enables two settings, one for the VIDEO input signals and one for other signals, to be stored in the memory. <Notes> While this item's setting is selected, the only information displayed on the screen is this item which appears at the bottom left regardless of the MENU POSI setting selected on the OSD screen. The sharpness can be set for VIDEO and all other input channels. Item I-P MODE Setting MODE2 MODE1 Description For switching the IP conversion mode. MODE2: Movement compensation mode MODE1: Normal mode <Note> This setting takes effect when progressive signals (1080/30P, 1080/25P, 1080/24P, 720/60P or 480/60P) are input. For details, refer to "Concerning the REMOTE specifications" (page 22). OFF: Normal images ON: Monochrome images <Notes> No adjustments are possible when RGB signals are input. When ON has been selected as this item's setting, the setting for the CHROMA image control is fixed at 0. When the setting is returned to OFF, the CHROMA setting prior to the change is restored. For setting the aspect ratio of the SD signals. For details, refer to "REMOTE specifications" (page 22). 16:9 : The images are displayed with a 16:9 aspect ratio. 4:3 : The images are displayed with a 4:3 aspect ratio. MONO COLOR TEMP. USER D93 D65 D56 GPI OFF ON SD ASPECT SHARPNESS MODE HIGH LOW GPI 16:9 4:3 SHARPNESS H 0 : : 2 30 SHARPNESS V 0 : : 2 30 The underlined setting indicates the factory setting mode. 18 MAIN MENU SYSTEM CONFIG Item BACKLIGHT 0 : OSD CONFIG Description Item Setting Description For selecting whether to display the remaining battery charge. OFF: The remaining charge is not displayed. For setting how long the status display is to remain on the screen. CONTINUE: The status display appears continuously at all times. 3SEC. OFF: The status display appears for three seconds. OFF: The status display does not appear. [. . . ] When a menu is displayed, the error is indicated in the menu area. At all other times, it is indicated on the status display. However, only the error will be displayed when 3SEC OFF or OFF has been selected as the STATUS DISPLAY item setting on the OSD screen. On the other hand, if OFF has been selected as the CRCC MESSAGE item setting on the OSD screen, the error will not be displayed even when it has been detected. [. . . ]