User manual PANASONIC CF-VDD721

[. . . ] Built for Humans and ErgoTrac are trademarks of Fujitsu PC Corporation. The following are registered trademarks of IBM Corporation:IBM, IBM PC AT, IBM PS/2. The following are registered trademarks of Microsoft Corpora ti on :M S , M S - DO S , Windows 95. PCMCIA is a trademark of the Personal Computer Memory Card International Association. [. . . ] When set to Enabled, a password (User or Supervisor) is required to access data on the Primary Slave interface. When set to Enabled , a password (User or Supervisor) is required to access data on the disk drive on the Secondary Master interface. Options Default Description 93 Section Three POINT Boot sector protection must be set to [Normal] to install or upgrade an operating system. Exiting from the Security Menu When you have finished setting the parame ters on the Security Menu, you can either exit from setup utility or move to another menu. If you wish to exit from setup utility, press the Esc key to go to the Exit Menu. If you wish to move to another menu, use the cursor keys. 94 LifeB ook 70 0 Series from Fuj itsu C onfi gu ri n g Your Li fe Book 700 S er ie s The Power menu allows you to set and change the power management parameters. Follow the instructions for Navigating Through the Setup Utility to make any changes. (See page 57. ) Table 3-14 shows the names of the menu fields for the Power menu, all of the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. POINT Most power management parameters can also be set from the Windows 95 desktop without entering the setup utility, using PowerPanel by Phoenix Technologies. Changing the settings with PowerPanel does not change what is stored in the CMOS memory. (See pages 40-44. ) POWER MENU ­ SETTING POWER MANAGEMENT FEATURE CONTROLS Figure 3-14 Power Menu 95 Section Three Table 3-14 Fields, Options and Defaults for the Power Menu. Menu Field Auto Save to Disk: Options Off; After 1 Hour. Default [Off] Description When set to After 1 Hour your notebook will automatically save all of system memory and the operating parameters to the hard drive and go to the pseudo-off if you leave your notebook in Suspend mode for an hour. Sets whether or not to Resume from a suspension state when a message is received by telephone line. This feature is not available if the Save-to-Disk mode is enabled. This feature applies to internal, external and PC Card modems. Sets whether or not to resume fr om a suspension state at a designated time. This feature is available from either the Suspend mode or the Save-to-Disk mode. Sets the designated time, on a 24-hour clock, when the notebook is to automatically resume operation from the Suspend state. The format of the clock setting is hours:minutes:seconds. Each segment of the time is set separately, either by incrementing or by typing in the numbers. You move between the segments with the Tab key or the Shift+Tab keys. This only applies when Resume on Time is set to On. [. . . ] 5, 13, 15-17, 38, 48, 137, 169, 172 Presentation profile . 42, 48, 50, 55-56, 139, 160, 176, 178, 180-181 Quiet boot . 4, 124, 131, 158, 160, 168, 171, 176-177, 181 Real time clock . 2, 15, 38, 161-162 189 Index Registration . [. . . ]