User manual PANASONIC CF-01XSDAPM

[. . . ] 17 Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Basic Operation Starting Up/Shutting Down. . . . . . . . . . . . . . . . 29 Battery Power. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 LCD (Touchscreen) . . . . . . . . . . . . . . . . . . . . . . . . . . 33 Useful Information Buttons. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 Quick Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When the confirmation message appears, tap [Yes]. D When the message "Backup data has been deleted. " appears, tap NOTE . When you turn on the wireless display next time, the calibration screen will appear. ( page 20) When returning the wireless display to its condition at the time of shipment Perform the following procedure while the wireless display is turned off. A Connect your wireless display to a power outlet. ( page 19) 31 Starting Up/Shutting Down B Press the power button with the keyboard button and USER button ( page 38) pressed until the message "Reset the device to factory default. . . " appears. When the [Enter Password] screen appears, enter the Supervisor Password and tap [OK]. C Select [Yes]. NOTE When you turn on the wireless display next time, the calibration screen will appear. ( page 20) Shutting Down (power off the wireless display) 1 Press the power button for one or two seconds until the message "Preparing to Power off. . . " appears. When shutting down forcefully, press the power button for four seconds or longer. 32 LCD (Touchscreen) Using the Stylus Use the stylus provided to perform operations on the touchscreen. The stylus is located in the stylus holder (A), and can be held like a pen or pencil. The following operations are possible on the touchscreen. Tapping You can select an item on the screen by tapping it with the stylus. This operation is called a "tap". Dragging You can drag on item on the screen by holding the stylus down over the item and then moving the stylus. If you press the keyboard button once more, the screen will return to [0 degrees (Landscape)]. You can set the screen to rotate to a preset position using Quick Menu, just like the button setting above. ( page 39) 35 Battery Power Battery Indicator Battery indicator Not lit Pulsing orange Green Red Blinking red Blinking orange Battery status The battery pack is not inserted or not being charged. The remaining battery is approximately 9% or less. The battery pack or the charging circuit is not operating normally. The battery cannot be charged temporarily due to the following reason: Its internal temperature is out of the acceptable range. NOTE Once the battery is fully charged, the wireless display performs recharging only when the battery level becomes less than approximately 95%, so overcharging is avoided. Checking the Remaining Battery Charge You can check the remaining battery charge using any of the following methods. Double-tap on the desktop, double-tap [Power] and tap the [Battery] page 38) and run Quick Menu tab. Press the keyboard button or USER button ( ( page 39). 36 You can reduce power consumption using the following method. When using the battery, the wireless display can be used for a longer period of time. Power conservation effects can be achieved even when the AC adaptor is connected. Double-tap on the desktop, dou- ble-tap [Power] and tap the [Schemes] tab. [. . . ] This Limited Warranty will be governed by the laws the State of New York, without regard to its conflict-of-laws rules. * * * To obtain service or technical assistance within the continental U. S. A. and Alaska. DIAL TOLL FREE: 1-800-LAPTOP5 Correspondence requesting product information should be sent to: Panasonic Computer Solutions Company 50 Meadowlands Parkway, Panazip 2F-5, Secaucus, NJ 07094 65 LIMITED WARRANTY For Canada PANASONIC COMPUTER AND PERIPHERALS LIMITED WARRANTY Coverage ­ Panasonic Canada Inc. ("PCI") warrants to you, the first end user customer, this computer product (excluding software media), when purchased from PCI or from a PCI authorized reseller, to be free from defects in materials and workmanship under normal use, subject to the terms set forth below, during the period of warranty coverage specified. Scope of Coverage Whole Product (except Batteries), AC adaptor and CDROM (if factory installed) Period of Coverage Three (3) Years from Date of Original End User Customer Purchase Type of Failure Coverage Defective Materials or Workmanship Defective Materials or Workmanship Batteries, CD-ROM (unless One (1) Year from Date of factory installed), Port Repli- Original End User Cuscator, Extra Memory Modtomer Purchase ules and all other Peripherals, Options and Accessories Remedy ­ In the event of a warranty claim, contact PCI's representatives within the applicable warranty period, identifying the nature of the defect claimed, at 1-800-668-8386 between 9:00 A. M. [. . . ]