User manual PANASONIC CF-08

[. . . ] OPERATING INSTRUCTIONS Wireless Display Model No. CF-08 Contents Getting Started Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Description of Parts . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Read Me First . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 First-time Operation. . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When the [Enter Password] screen appears, enter the Supervisor Password and tap [OK]. C Select [Yes]. NOTE When you turn on the wireless display next time, the calibration screen will appear. ( page 20) Shutting Down (power off the wireless display) 1 Press the power button for one or two seconds until the message "Preparing to Power off. . . " appears. When shutting down forcefully, press the power button for four seconds or longer. 32 LCD (Touchscreen) Using the Stylus Use the stylus provided to perform operations on the touchscreen. The stylus is located in the stylus holder (A), and can be held like a pen or pencil. The following operations are possible on the touchscreen. Tapping You can select an item on the screen by tapping it with the stylus. This operation is called a "tap". Dragging You can drag on item on the screen by holding the stylus down over the item and then moving the stylus. This operation is called a "drag". Tapping and Holding You can tap and hold the stylus on an item to see a list of actions available for that item. On the pop-up menu that appears, tap the action you want to perform. Right-clicking You can execute the right click operation. ( page 38) Handling the Stylus Clean the stylus tip and screen prior to operation. Foreign particles can scratch the screen and impede the operation of the stylus. Use the provided stylus only on the screen. Using it for any other purpose may damage the stylus and scratch the screen. 33 LCD (Touchscreen) Handling the Touchscreen Use the provided stylus with CF-08. Do not use an implement other than the stylus that comes with the wireless display. Do not place any object on the surface or press down forcefully with sharppointed objects (e. g. , nails), or hard objects that can leave marks (e. g. , pencils and ball point pens). Do not operate the wireless display when such things as dust are on the LCD. Do not allow substances such as oil to contact the LCD. The cursor may not work properly in such cases. Aligning the touchscreen Align the touchscreen if the cursor does not correctly move to the position where the stylus touches the touchscreen of the wireless display. A Double-tap on the desktop, and double-tap [Stylus]. B Tap the [Calibration] tab, and tap [Recalibrate]. Rotating the screen To rotate the screen, perform the following procedure. A Double-tap on the desktop. B Double-tap [Rotate]. C Add the check mark for [0 degrees (Landscape)], [90 degrees], [180 degrees] or [270 degrees], and tap [Rotate]. The screen will rotate to the position selected. [. . . ] (excluding holidays) for instructions on how to obtain service. A purchase receipt or other proof of date of original purchase is required before warranty service is performed. Defective parts covered by this Limited Warranty will be repaired or replaced with new or comparable rebuilt parts on an exchange basis. Warranty replacement or repair is subject to the terms of this Limited Warranty for the balance of the original period of warranty coverage. [. . . ]