User manual PANASONIC CF-71DJ48AAM

[. . . ] Press and hold [Fn] key, and then press [F5] key. You may need to double-click in some cases. Page in these Operating Instructions or in the Reference Manual. Reference to the on-screen manuals. Some illustrations are simplified to help your understanding and may look different from the actual unit. [. . . ] Do not convert the hard disk to a dynamic disk. NOTE The backup area requires at least half of the entire hard disk capacity. If the capacity is not sufficient, the backup area will not be created. When the backup area is created, the usable hard disk capacity will be less than half of the original capacity. The backup area cannot be accessed from Windows. The backup data cannot be copied to CD-R or other removable disk media. When the hard disk backup function is executed, data in the backup area will be overwritten and the data previously stored will be lost. Creating the Backup Area Preparation Prepare the following items: · The Product Recovery DVD-ROM (included) · Panasonic CD/DVD drive (included) Remove all peripherals (except for the CD/DVD drive). Connect the AC adaptor and do not remove it until hard disk backup is complete. Turn off the computer and insert the CD/DVD drive into the multimedia pocket ( Reference Manual "Multimedia Pocket"). Turn on the computer, and press F2 several times while [Panasonic] boot screen is displayed. The Setup Utility starts up. If the password is requested, enter the Supervisor Password. 3 4 5 Select the [Boot] menu and select [IDE MP], and then press F6 until [IDE MP] moves up to the top of the boot priority order. Select the [Security] menu and set [CD/DVD Operation] to [Enable]. Set the Product Recovery DVD-ROM into the CD/DVD drive. 16 6 Press F10. Erase the data using the hard disk data erase utility before disposing of or transferring ownership of this computer. During backup, the message [#1805 cannot write image file] may appear, and the backup function may be interrupted. In this case, execute the backup function again. If the backup function is completed normally, the hard disk has no problem. To disable the hard disk backup function Perform the reinstallation procedure. CAUTION Troubleshooting Appendix All data in the backup area and hard disk will be erased. A Perform steps 1-9 for "Reinstalling Software" ( page 20). B Select [1] or [2] to execute the reinstallation at the screen for executing the reinstallation. · [1]: The hard disk backup function is disabled. · [2]: The hard disk backup function is disabled. However the hard disk backup function cannot be reenabled because the hard disk has been divided into partitions. · [3]: The hard disk backup function is not disabled. 18 Hard Disk Data Erase Utility When disposing the computer or transferring the ownership, erase all hard disk data in order to avoid data leakage. Even if you erase the data or initialize the hard disk using normal Windows commands, the data can be read with some special software. [. . . ] ("PCI") warrants to you, the first end user customer, this computer product (excluding software media), when purchased from PCI or from a PCI authorized reseller, to be free from defects in materials and workmanship under normal use, subject to the terms set forth below, during the period of warranty coverage specified. Scope of Coverage Whole Product (except Batteries), AC adaptor and CDROM (if factory installed) Batteries, CD-ROM (unless factory installed), Port Replicator, Extra Memory Modules and all other Peripherals, Options and Accessories Period of Coverage Type of Failure Coverage Three (3) Years from Date of Origi- Defective Materials or Workmannal End User Customer Purchase ship One (1) Year from Date of Original End User Customer Purchase Defective Materials or Workmanship No Coverage ­ This Limited Warranty does not cover products purchased outside Canada. Neither does it cover damage to, failure of, or defects in a product or accessory through mishandling, improper installation, abnormal use, misuse, neglect, accident, introduction of liquid or other foreign matter into the product, alteration or servicing by anyone not authorized by PCI, or act of God. Carefully pack the product, preferably in the original carton. Include details of defect claimed and proof of date of original purchase. [. . . ]