User manual PANASONIC CF-W2XXXX

[. . . ] Personal Computer OPERATING INSTRUCTIONS Model No. CF-W2 Series Getting Started Appendix Troubleshooting Operation Contents XP 2000 Getting Started Page Read Me First. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 First-time Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Reference Manual · Read Me First · Key Combinations · LED Indicators Operation Starting Up/Shutting Down . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Touch Pad . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] This message may appear when certain USB devices are connected. Remove the USB device, or set [Legacy USB Support] in [Advanced] menu of the Setup Utility to [Disable]. If the message still appears even after trying the above two measures, this may be an indication that some type of hard disk failure has occurred. Contact your technical support office ( page 45). The date and time are incorrect When "Invalid system disk. Replace the disk, and then press any key. " (or a similar message) is displayed 23 Troubleshooting When resuming from the standby or hibernation mode, [Enter Password] does not appear even if a password has been set in the Setup Utility Dealing with Problems Starting Up (continued) When the administrator password is forgotten (Summary) Set the password again in the following procedure. Windows XP If you have created a password reset disk ( page 16), a message is displayed when you fail to correctly enter the password. Follow the message's instructions and set the password again by using the password reset disk. If you have not created a password reset disk, after reinstalling, setup Windows and then set the password again. Windows 2000 After reinstalling, setup Windows and then set the password again. Press F9 in the Setup Utility ( "Setup Utility"). This will restore the Setup Utility's settings to their default values (except the password settings). Check a disk error using the following procedure. Windows XP Select [Local Disk(C:)] with the right button in [start] - [My Computer], and select [Properties]. Windows 2000 Select [Local Disk(C:)] with the right button in [My Computer], and select [Properties]. 3 Select [Start] after selecting required items in [Check disk options]. At startup, hold down F8 when [Panasonic] boot screen disappears, and release your finger when the Windows Advanced Option Menu is displayed. Start the computer in Safe Mode, and confirm the details of the error. When the previous item is not the cause Display No display after powering on When there is no display to an external display, · Check your cable connection to the external display. · Confirm your display is powered on. · Check the settings for your external display. The display destination may be set to the external display. Try changing the display destination by pressing Fn + F3 . If you want to switch the display destination repeatedly by pressing Fn + F3 , make sure that the display destination has switched completely each time before pressing Fn + F3 again. [. . . ] Defective parts covered by this Limited Warranty will be repaired or replaced with new or comparable rebuilt parts on an exchange basis. Warranty replacement or repair is subject to the terms of this Limited Warranty for the balance of the original period of warranty coverage. No Coverage ­ This Limited Warranty does not cover products purchased outside Canada. Neither does it cover damage to, failure of, or defects in a product or accessory through mishandling, improper installation, abnormal use, misuse, neglect, accident, introduction of liquid or other foreign matter into the product, alteration or servicing by anyone not authorized by PCI, or act of God. IF YOU SHIP THE PRODUCT FOR WARRANTY SERVICE Carefully pack the product, preferably in the original carton. [. . . ]