User manual PANASONIC CQ-3100

[. . . ] ¡ When a broadcast of FM Radio Data System is received, the clock is set automatically by the CT (Clock Time) service. ¡ Hold down []] or [[] to change numbers rapidly. General Power Supply Tone Controls (Bass) Tone Controls (Treble) Current Consumption Maximum Power Output Speaker Impedance Pre-Amp Output Voltage Pre-Amp Output Impedance Dimensions (Main Unit) Weight (Main Unit) : 12 V DC (11 V ­ 16 V), Negative Ground : ±12 dB (100 Hz) : ±12 dB (10 kHz) : Less than 2. 5 A (CD mode, 0. 5 W 4 channels) : 45 W x 4 (4 ) :4 ­ 8 : 2. 5 V (CD mode, 1 kHz, 0 dB) : 200 : 178(W) x 50(H) x 160(D) mm : 1. 3 kg FM Stereo Radio Frequency Range Usable Sensitivity Stereo Separation : 87. 5 MHz ­ 108 MHz : 6 dB/µV (S/N 30 dB) : 35 dB (1 kHz) CQ-C1021NW/C1011NW/C1001NW Operating Instructions BAND VOL APM Frequency Range Usable Sensitivity : 531 kHz ­ 1 602 kHz : 28 dB/µV (S/N 20 dB) AM (LW) Radio Frequency Range Usable Sensitivity : 153 kHz ­ 279 kHz : 32 dB/µV (S/N 20 dB) CQ-C1021N TUNE/TRACK Differences among 3 models AM (MW) Radio This operating instruction manual is for 3 models CQ-C1021NW, CQ-3100 and CQ-C1001NW. All illustrations throughout this manual represent model CQ-C1021NW unless otherwise specified. The following table describes the differences among 3 models. CD Player Sampling frequency DA converter Pick-up type Light source Wave length Frequency response Signal to noise ratio Total harmonic distortion Wow and flutter Channel separation : 8 times oversampling : 1 bit DAC System : Astigma 3-beam : Semiconductor laser : 790 nm : 20 Hz ­ 20 kHz (±1 dB) : 96 dB : 0. 01 % (1 kHz) : Below measurable limits : 75 dB Features Display colour Models CQ-C1021NW Blue Red CQ-3100 Black Red CQ-C1001NW Black Green 1 Select the radio AM mode. (a "Radio (AM [LW/MW]/FM)") NO MO LOC PTY D·M SEL PWR Key/disc slot illumination colour SRC MUTE/SQ UME RANDOM SCAN REPEAT TA CT R AF EG 1 2 3 4 5 6 DISP (CQ-C1021NW) Notes: ¡ Specifications and design are subject to modification without notice due to improvements. [. . . ] The traffic announcement having finished, the unit will return to the previous mode. (TA Standby Mode) TA (Traffic Announcement) Display change Useful functions such as AF, TA, PTY, etc. are available in the RDS (Radio Data System)-ready areas. TA ON/OFF Pressing [TA] toggles TA on and off. Traffic Information Only (TA Mute) For listening to only traffic information, activate TA and set the volume to 0 in FM mode. Once traffic information starts, the volume changes to the TA volume. (a "Audio Settings") Player mode display (Default) repeat indicator PTY (Programme Type) The following functions are available when the PTY mode is active. ¡ The PTY of receiving station appears. ¡ Programmes can be searched for by PTY. Note: PTY language can be selected. [u] (Eject) ejects the disc. APM /TRAC K TUNE AF (Alternative Frequency) The following functions are available when the AF mode is active ( lights). PWR CT What is RDS? (y / 5) (Pause/Play) toggles pause/play in the player source. BAND ME VOLU CQ-C1021N NO MO LOC PTY D·M SEL SRC MUTE/SQ RANDOM SCAN REPEAT TA R AF EG 1 2 3 4 5 6 DISP [DISP] (Display) switches the information on the display. Random play Scan play The first 10 seconds of each track is played in sequence. Random, Repeat, Scan [SRC] (Source) selects a source. indicator (RANDOM)/(SCAN)/(REPEAT) toggles on/off each play mode. All the available tracks are played in a random sequence. Press [4] (RANDOM). Press again to cancel. Press [5] (SCAN). ¡ When receiving conditions become bad, a station with better receiving conditions is automatically tuned into. ¡ When executing APM, only RDS stations are selected. ¡ When calling up a preset station, a best receiving station is selected automatically. ¡ This player cannot play the CD-R/RW discs if the session is not closed. ¡ This player cannot play the CD-R/RW discs which contain other than CD-DA data (MP3/WMA, Video CD, etc. ). ¡ Be sure to observe the instructions of the CD-R/RW disc for handling it. AF Level Press [AF] to select AF level. AF Range (Region) Holding down [AF] (REG: Region) for more than 2 seconds toggles region mode on/off. REG OFF: The frequency is changed also for programmes outside the region. (Default) REG ON: The frequency is changed only for programmes within the region. 3 4 5 6 SPORT POP M CLASSICS MUSIC PTY Preset Change Original PTY presets can be changed as you like. Operation Flow Press [TRACK s] / [TRACK d]. Note: To perform fast forward/reverse, hold down either of them. AF (Alternative Frequency) Notes on discs Low level AF operating sensitivity. (Default) Another station in the same PTY is searched for by pressing [BAND]. Notes: ¡ When there is no corresponding programme type station, "NONE" is displayed. ¡ A desired PTY appears for 5 seconds. ¡ Preset contents are changeable. 1 Select a PTY that you would like to preset. 2 Follow the procedure of ordinary presetting. (a "Station Preset" in "Radio (AM [LW/MW]/FM)") High level AF operating sensitivity. PTY Language Selection The language displayed on the screen is selectable. (English or Swedish) When the AF network of an RDS station is not required. PI Seek (Programme Identification Seek) If reception becomes poor when tuning in a preset station, press the same preset number button. [. . . ] Sluit de luidsprekers als volgt aan. Precautions (ISO Connector) The pin arrangement of the power connector conforms to ISO standard. Please check that the pin arrangement of the connector in your car conforms to ISO standard. For car types A and B, change the wiring of the red and yellow leads as shown at below. After connection, insulate the portions marked () with insulating tape. [. . . ]