User manual PANASONIC CQ-DF401

[. . . ] All illustrations throughout this manual represent model CQ-C1121U unless otherwise specified. The following table describes the differences among 3 models. General Power supply Current consumption Maximum power output : 12 V DC (11 - 16 V DC), negative ground : Less than 2. 2 A (CD mode; 0. 5 W 4 channels) : 50 W x 4 (at 1 kHz), volume control maximum (for CQ-C1121/C1101U) : 45 W x 4 (at 1 kHz), volume control maximum (for CQ-C1001U) : Bass: ±12 dB at 100 Hz, Treble: ±12 dB at 10 kHz :4 - 8 : 2. 5 V (CD mode, 1 kHz, 0 dB) : 200 : 178 x 50 x 160 mm {7" x 1 15/16" x 6 5/16"} : 1. 3 kg {2 lbs. 14 oz} FM Stereo Radio Frequency range Usable sensitivity 50 dB quieting sensitivity Frequency response Alternate channel selectivity Stereo separation Image response ratio IF response ratio Signal/noise ratio : 87. 9 MHz­107. 9 MHz : 11. 0 dBf. (75 ) : 30 Hz­15 kHz (±3 dB) : 75 dB : 35 dB (1 kHz) : 75 dB : 100 dB : 62 dB CQ-C1121U/C1101U/C1001U Operating Instructions BAND APM U. S. A. PANASONIC CONSUMER ELECTRONICS COMPANY, DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA One Panasonic Way, Secaucus, New Jersey 07094 PANASONIC SALES COMPANY, DIVISION OF MATSUSHITA ELECTRIC OF PUERTO RICO, INC. [. . . ] ¡ If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth. Observe the following cautions when installing. Refer wiring and installation to qualified service personnel. Installation of this unit requires special skills and experience. For maximum safety, have it installed by your dealer. Panasonic is not liable for any problems resulting from your own installation of the unit. Use the proper power supply. This product is designed for operation with a negative grounded 12 V DC battery system. Never operate this product with other battery systems, especially a 24 V DC battery system. 5 Adjust the hour. Clock Setting [[]: sets the hour ahead. []]: sets the hour back. Never use safety-related components for installation, grounding, and other such functions. Do not use safety-related vehicle components (fuel tank, brake, suspension, steering wheel, pedals, airbag, etc. ) for wiring or fixing the product or its accessories. Keep batteries and insulation film out of reach of infants. Batteries and insulation film can be ingested, so keep them out of the reach of infants. If an infant ingests a battery or insulation film, please seek immediate medical attention. 6 Press [DISP] (CLOCK). Face Plate Removing/Mounting Protect the Deck Mechanism. Do not insert any foreign objects into the slot of this unit. Installing the product on the air bag cover or in a location where it interferes with airbag operation is prohibited. Check for piping, gasoline tank, electric wiring, and other items before installing the product. If you need to open a hole in the vehicle chassis to attach or wire the product, first check where the wire harness, gasoline tank, and electric wiring are located. Then open the hole from outside if possible. Follow the instructions to install and wire the product. Not following the instructions to properly install and wire the product could cause an accident or fire. Take care not to damage the leads. When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. Frequency Band Preset Number Display change Press [DISP] (Display) to change the display. CQ-C1121U CQ-C1101U BAND VO L [VOL] selects a value in the audio menu. (PUSH SEL) (Push to Select) selects items in the audio menu. CQ-C1121U PUSH SEL D·M PWR CLOCK DO SRC MUTE 7 8 9 10 11 12 SQ/SCAN REP M RA Radio mode display (Default) CQ-C1001U BAND APM 1 2 3 4 5 6 DISP N TUNE/TRACK D·M APM APM APM SEL PWR TUNE/TRACK BAND ME VOLU MUTE BAND VO L VO BAND L CQ-C1121U PUSH SEL CQ-C1121U PUSH SEL D·M Clock display PWR CLOCK DO [] or [] selects a value in the audio menu. [SEL] (Select) selects items in the audio menu. SEL PWR [DISP] (Display) exits from the audio menu. ME VOLU MUTE SRC PWR CLOCK DO SRC MUTE 7 8 9 10 11 12 SQ/SCAN REP M SRC SRC MUTE 7 8 9 10 11 12 SQ/SCAN REP M 1 2 3 4 5 6 DISP 1 2 3 4 5 6 DISP [DISP] (Display) switches the information on the display. lights while receiving the D·M (Direct Memory) station. RA N RA 1 Display the audio menu. CQ-C1121U CQ-C1001U CQ-C1101U Note: If no operation takes place for more than 5 seconds in the audio menu (2 seconds in Main volume adjustment), the display returns to the regular mode. N lights when mute is on. [SQ] (Sound Quality) selects a sound type (SQ). Preset buttons [1] to [6] selects a preset station in the radio source, and presets the current station. (Hold down it for more than 2 seconds) [TUNE ]] [TUNE [] down/up the frequency. (Hold down it for more than 2 seconds for seek tuning. ) Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively. Preset stations can be simply called up by pressing one of the preset buttons from [1] to [6]. Press [VOL] (PUSH SEL: Select). Press [SEL] (Select). Manual station preset 2 Select a mode to be adjusted. CQ-C1121U CQ-C1001U CQ-C1101U 3 Adjust. CQ-C1121U CQ-C1101U [] [] Power On/Off Turn your car's ignition switch to the ACC or ON position. SQ (Sound Quality) 1 Tune into a station. 2 Hold down one of the preset buttons from [1] to [6] for more than 2 seconds. Press [VOL] (PUSH SEL: Select). Press [SEL] (Select). Turn [VOL]. CQ-C1001U Power on: Press [SRC] (PWR: Power). [. . . ] Back side w Put a battery in the case with (+)-side facing up. e Put the case back. Warning ¡Keep batteries away from children to avoid the risk of accidents. If an infant ingests a battery, please seek immediate medical attention. Caution ¡ Remove and dispose of the old battery immediately. [. . . ]