User manual PANASONIC CQ-DF402

[. . . ] It is important that you fully understand the meanings of the pictographs in order to use this manual and the system properly. CQ-C1321NW/C1311NW/C1301NW Operating Instructions VO Caution Observe the following cautions when using this unit. Keep the sound volume at an appropriate level. Keep the volume level low enough to be aware of road and traffic conditions while driving. Observe the following cautions when installing. Refer wiring and installation to qualified service personnel. Installation of this unit requires special skills and experience. For maximum safety, have it installed by your dealer. Panasonic is not liable for any problems resulting from your own installation of the unit. First Time Power On This manual uses pictographs to show you how to use the product Label Indications and Their Locations CAUTION LASER RADIATION WHEN OPEN. DO NOT STARE INTO BEAM. CLASS 1 LASER PRODUCT ignition 1 Set your car'sACC or ON switch to the position. [. . . ] 2 Hold down one of the preset buttons from [1] to [6] for more than 2 seconds. ¡ Do not insert a disc when the indicator lights. ¡ Refer to the section of "Notes on Discs" and "Notes on MP3/WMA". ¡ This unit does not support 8 cm discs. ¡ If you insert an 8 cm disc and cannot eject it, turn ACC of your car off once and turn it on again, then press [u] (Eject). ¡ Do not insert foreign objects into the disc slot. Random play Folder repeat play (MP3/WMA) The current folder is repeated. Radio Disc Player Station Preset Random, Repeat, Scan Volume Adjustment (Setting Range: 0 to 40, Default: 18) Turn [VOL]. Note: Hold down either of them for more than 0. 5 seconds and release it for seek tuning. 1 Select a band. 2 Hold down [BAND] (APM) for more than 2 seconds. The preset stations under best receiving conditions are received for 5 seconds each after presetting the stations (SCAN). To stop scanning, press one of the buttons from [1] to [6]. Note: New stations overwrite existing saved stations. 1 Press [SRC] to select the Disc Player (blinks once) Note: New stations overwrite existing saved stations. Folder selection (MP3/WMA) Press [{] / [}]. All the available songs (tracks/files) are played in a random sequence. Press [4] (RANDOM). Press again to cancel. source. Hold down [6] (REPEAT) for more than 2 seconds. Hold down again to cancel. 2 Select a desired portion. Pause Folder random play (MP3/WMA) All the available files in current folder are played in a random sequence. Scan play The first 10 seconds of each songs (tracks/files) is played in sequence. Preset station selection Press the corresponding preset button from [1] to [6] to tune into a preset station. Operation Flow Track/file selection Press [6] / [7]. Note: To perform fast forward/reverse, hold down either of them. Press [BAND] (y / 5). Press again to cancel. Mute ON: Press [MUTE]. ( OFF: Press [MUTE] again. lights. ) Hold down [4] (RANDOM) for more than 2 seconds. ¡ The PTY of receiving station appears. ¡ Programs can be searched for by PTY. (a "Function Settings") PWR PTY PWR /TRAC K TUNE D·M PUSH SEL CQ-C1321N ER LD FO D·M PUSH SEL MUTE/SQ SCROLL RANDOM SCAN REPEAT PTY SRC TA/AF 1 2 3 4 5 6 DISP [DISP] (Display) exits from the audio menu. SRC MUTE/SQ SCROLL RANDOM SCAN REPEAT TA/AF 1 2 3 4 5 6 DISP [DISP] (Display) exits from the function menu. Trouble Check point Trouble Check point AF (Alternative Frequency) The following functions are available when the AF mode is active ( lights). Common Start the engine. (Or turn the ignition switch to the ACC position. ) Verify the wiring. (battery lead, power lead, ground lead, etc. ) Fuse blown (Contact the nearest Panasonic Service Centre. ) Ask a professional for fuse replacement. Wait until the dew disappears before turning on the unit. Radio Frequent noise Tune in to another station of high-intensity waves. Make sure that the antenna mounted point is grounded properly. The preset memory is cleared to return to the original factory setting when the power connector or battery is disconnected. 1 Press [VOL] (PUSH SEL) to display the audio menu display. PTY On/Off Holding down [DISP] (PTY) for more than 2 seconds toggles PTY mode on and off. 1 Hold down [VOL] (PUSH SEL) for more than 2 seconds to display the function menu display. Note: If no operation takes place for more than 7 seconds in the function menu, the display returns to the regular mode. What is RDS? No power ¡ When receiving conditions become bad, a station with better receiving conditions is automatically tuned in to. ¡ When executing APM, only RDS stations are selected. ¡ When calling up a preset station, a best receiving station is selected automatically. (BSR Best Stations Research) Notes: ¡ The AF sensitivity can be adjusted. [. . . ] Sluit de luidsprekers als volgt aan. Precautions (ISO Connector) The pin arrangement of the power connector conforms to ISO standard. Please check that the pin arrangement of the connector in your car conforms to ISO standard. For car types A and B, change the wiring of the red and yellow leads as shown at below. After connection, insulate the portions marked () with insulating tape. [. . . ]