User manual PANASONIC CQ-DP965

[. . . ] 10 Name of Controls and Functions . . . . . . . . . . . . . . . . . . 11 Power and Basic Operations . . . . . . . . . . . . . . . . . . . . . . . . 12 Radio Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 CD Player Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If there are no plastic caps on the stereo hooking wires, insulate all exposed leads with electrical tape until you are ready to use them. Identify the leads in the following order. Power Lead If your car has a radio or is pre-wired for one : Cut the connector wires one at a time from the plug (leaving the leads as long as possible) so that you can work with individual leads. If your car has a radio or is pre-wired for one: With the ignition and headlights off, identify the car battery lead by grounding one lead of the test bulb to the chassis and checking the remaining exposed wires from the cut radio connector plug. If your car is not wired for an audio unit : Go to the fuse block and find the fuse port for the battery, usually marked BAT. Speakers Identify the car speaker leads. There will be two leads for each speaker, usually color coded. A handy way to identify the speaker leads and the speaker they connect with is to test the leads using a 1. 5 volt AA battery as follows. Hold one lead against one pole of the battery and stroke the other lead across the other pole. You will hear a scraping sound in a speaker if you are holding a speaker lead. If not, keep testing different lead combinations until you have located all the speaker leads. When you label them, include the speaker location for each. Lower or higher impedance speakers will affect output and can cause both speaker and stereo unit damage. Antenna Connect the antenna by plugging the antenna lead into the antenna receptacle. Equipment Connect any optional equipment such as an amplifier, according to the instructions furnished with the equipment. Leave about 30 cm of distance between the speaker cords/amplifier unit and the antenna/ antenna extension cord. Read the operating and installation instructions of any equipment you will connect to this unit. Power Connect the red power lead to the correct wire or to the appropriate fuse port on block. If the stereo unit functions properly with connections made, disconnect the wires ceed to the final installation. car radio the fuse all these and pro- Illumination 1. Connect to light switch, the control button are illuminated. 2. Can not find the light switch, connect the illumination lead (orange with white stripe) to accessory (ACC). Final Installation Lead Connections Connect all wires, making sure that each connection is insulated and secure. Bundle all loose wires and fasten them with tape so they won't fall down later. After making a few final checks, you're ready to enjoy your new auto stereo system. Connect the power cord after completion of other connections to prevent shortings. CAUTION : Never ground the speaker cords. [. . . ] a Open the panel and press [u] (CD EJECT) button. If failure persists, press the reset switch. If normal operation is not restored yet, call the store where you purchased the unit or the nearest Panasonic Service Center to ask for repairs. Action was taken to start playing before disc is fully ejected. [. . . ]