User manual PANASONIC CQ-2100EU

[. . . ] It is important that you fully understand the meanings of the pictographs in order to use this manual and the system properly. This pictograph intends to alert you to the presence of important operating instructions and Warning installation instructions. Failure to heed the instructions may result in severe injury or death. Caution This pictograph intends to alert you to the presence of important operating instructions and installation instructions. Failure to heed the instructions may result in injury or material damage. Warning Observe the following warnings when using this unit. The driver should neither watch the display nor operate the system while driving. Watching the display or operating the system will distract the driver from looking ahead of the vehicle and can cause accidents. Always stop the vehicle in a safe location and use the parking brake before watching the display or operating the system. Observe the following warnings when installing. Disconnect the lead from the negative (­) battery terminal before installation. Wiring and installation with the negative (­) battery terminal connected may cause electrical shock and injury due to a short circuit. [. . . ] Notes: ¡ Direct selection can be executed with [1] to [6] buttons on remote control. ¡ You can switch between 6 and 18 for FM presetting stations. (EACH BAND/ALL BAND) ¡ Preset stations are changeable. (Preset Swap) Manual station preset more. 3 Turn [VOL] to select a preset number. or Auto Preset Memory (APM) Stations with good receiving conditions automatically preset. more, and the frequency is stored at the selected preset number. 1 Select a band. 2 Hold down CQ-2100EU [BAND] (APM) for 2 sec. or more. / /SET/APM BAND DISP TILT OPEN Notes: ¡ In step 2, a station can be registered by holding down the numeric button [1] to [6] for 2 sec. ¡ To stop presetting stations, press [DISP: DISPLAY]. ¡ The operation above allows users to replace the current station with the station preset in the selected number while selecting a preset station. (Preset Swap) The preset stations under best receiving conditions are received for 5 sec. each after presetting the stations (SCAN). or more. English 1 Press [MENU] to display the menu disW W RANDOM : Off (default) MP3/WMA/AAC Player This unit can play MP3, WMA, and AAC files. When a disc is already loaded, press [SOURCE] to select the compressed audio mode. 1 Press [uOPEN] to open the face plate. When a disc is already loaded ( will automatically be ejected. lights), the disc L PU VO SH SEL / SRS W CQ-2100EU SOURCE SQ MENU O PWR W DIM TUNE TRACK FOLDER /P-SET/DISC / /SET/APM BAND DISP MUTE SBC-SW DM TILT OPEN LIST 2 Load a disc with the printed side facing up. Operation Flow The face plate closes automatically, and the unit recognizes the disc and starts playing automatically, too. (It may take several minutes to start for a disc that has a lot of files. ) 3 Select a desired portion. Folder selection [}] (FOLDER): Next folder [{] (FOLDER): Preceding folder Printed side File selection [7] (TRACK): Next file [6] (TRACK): Preceding file (press twice) Note: Hold down for fast forward/reverse. Pause Press [BAND] (h / 5). Press again to cancel. 4 Press [uOPEN] to eject the disc. Note: The panel automatically closes after 20 seconds. File number Time Compressed Audio Player Mode Display Folder number File type indicator Information Display Notes: ¡ For scrolling text, hold down [DISP: DISPLAY] for 2 sec. ¡ "NO TEXT" is displayed when there is no information on the disc. Play Mode indicators Lights when each mode is activated. Lights when the disc is loaded. (Folder Random) (Folder Repeat) (Folder Scan) 24 CQ-2100EU Notes: ¡ Refer to the pages 26 and 27 for cautions. ¡ This unit does not support a MIX mode CD (a CD containing both CD-DA and compressed audio files). In case of using such a CD, problems may occur such as anacoustic playback. Random and Repeat play can be set. Random, Repeat Play (Compressed Audio Player Menu Display) 1 Press [MENU] to display the menu display. For using the remote control, hold down [SEL] (MENU) for 2 sec. [. . . ] The sensor is exposed to direct sunlight. (The remote control unit may not be operable when the sensor is exposed to direct sunlight. In such a case, the system is not faulty. ) a Block off sunlight to the sensor. 36 Remote control unit CQ-2100EU Error Display Messages Display Possible cause a Possible solution The disc is dirty, or is upside down. a Check the disc. CD/Compressed Audio No operation by some cause. [. . . ]