User manual PANASONIC CQ-C1115N

[. . . ] CD Player/Receiver English Safety Information Read the operating instructions for the unit and all other components of your car audio system carefully before using the system. They contain instructions about how to use the system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual. Preparation This manual uses pictographs to show you how to use the product safely and to alert you to potential dangers resulting from improper connections and operations. The meanings of the pictographs are explained below. [. . . ] For maximum safety, have it installed by your dealer. Panasonic is not liable for any problems resulting from your own installation of the unit. 2 Hold down [DISP] (CLOCK) for more than 2 seconds. Use the proper power supply. This product is designed for operation with a negative grounded 12 V DC battery system. []]: sets the minute back. In the case of installation to an airbag-equipped car, confirm warnings and cautions of the vehicle manufacturer before installation. Make sure the leads do not interfere with driving or getting in and out of the vehicle. Insulate all exposed wires to prevent short circuiting. 6 Press [DISP] (CLOCK). Notes: ¡ "AdJ" is displayed before adjusting the clock. ¡ Hold down []] or [[] to change numbers rapidly. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. Information on Disposal in other Countries outside the European Union This symbol is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal. Accessories Operating Instructions Notes on Discs Installation kit (ZZBISC1021N-J) Lock Cancel Plate Notes: ¡ The number in parentheses underneath each accessory part name is the part Q'ty: 2 number for maintenance and service. ¡ Accessories and their part numbers are subject to modification without prior notice due to improvements. Q'ty: 1 ¡ Mounting Collar and Trim Plate are mounted on the main unit at shipment. Q'ty: 1 If you use commercial CDs, they must have the label shown at right. Some copy-protected music CDs are not playable. Maintenance Your product is designed and manufactured to ensure the minimum of maintenance. Use a dry, soft cloth for routine exterior cleaning. Never use benzine, thinner, or other solvents. Specifications Power supply Current consumption Tone adjustment range Dimensions (W x H x D) Weight Maximum power output Power output Speaker impedance DC 12 V (11 ­ 16 V), test voltage 14. 4 V, negative ground Less than 2. 2 A (CD mode; 0. 5 W x 4 channels) Bass: ±12 dB at 100 Hz, Treble: ±12 dB at 10 kHz 178 x 50 x 155 mm 1. 3 kg 45 W x 4 channels (at 1 kHz), volume control maximum 20 W x 4 (DIN 45 324, at 4 ) 4­8 Direct Sales at Panasonic UK (English :YFM284C651CA) FM Frequency Range Usable Sensitivity Stereo Separation 87. 5 MHz ­ 108 MHz 6 dB/µV (S/N 30 dB) 35 dB (at 1 kHz) 531 kHz ­ 1 602 kHz 28 dB/µV (S/N 20 dB) Removing Mounting 1 2 Press [ ]. 3 Pull it out toward you. Turn off the power. 1 2 Press the right end of face plate until a AM (MW) Frequency Range Usable Sensitivity Slide the left side of the face plate in place. General [VOLUME] [VOLUME] adjusts the volume. [D·M] (Direct Memory) tunes into the station memorized in D·M. (Hold down it for more than 2 seconds to memorize the current station. ) Radio (AM [MW]/FM) [BAND] selects a band in the radio source. (APM) (Auto Preset Memory) executes APM in the radio source. (Hold it down for more than 2 seconds. ) (Stereo) indicator [D·M] (Direct Memory) tunes into the station memorized in D·M. (Hold down it for more than 2 seconds to memorize the current station. ) lights while receiving an FM stereo signal. Frequency Band Preset Number Disc Player Display change Press [DISP] to change the display. AM (MW) mode: Disc slot takes a disc in with the printed side facing up. [6] [7] skip to the previous/next track in the player source. [. . . ] Note: New stations overwrite existing saved stations. Hold down [REP] (RANDOM) for more than 2 seconds. Hold down again to cancel. Hold down [SQ] (SCAN) for more than 2 seconds. Random, Repeat, Scan Radio Disc Player Preset station selection Press the corresponding preset button from [1] to [6] to tune into a preset station. Volume Adjustment (Setting Range: 0 to 40, Default: 18) UP :Press [] Down :Press [] 1 Press [SRC] to select the Disc Player source. Pause Press [BAND] (y / 5). Press again to cancel. Repeat play The current (track) is repeated. (blinks during scanning) Hold down again to cancel. 2 Select a desired portion. Operation Flow Track selection Press [6] / [7]. Note: To perform fast forward/reverse, hold down either of them. Press [REP] (REPEAT). Press again to cancel. Direct Memory D·M station calling D·M station writing 1 Press [D·M]. Press again to cancel. Mute ON: Press [MUTE]. [. . . ]