User manual PANASONIC CQ-D50L

[. . . ] These limits are designed to provide reasonable protection against harmful interference in an automobile installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio reception, which can be determined by turning the equipment off and on, the user is encouraged to consult the dealer or an experience radio technician for help. [. . . ] [6TRACK]: Back to the beginning of the current track. (Press twice. ) Display Change Press [DISP] to switch to the clock display. CD player: Track scan play CD player CD changer Press [BAND] (SCAN). The first 10 seconds of each track on the disc are played in sequence. Press and hold [BAND] (SCAN) for more than 2 seconds. The first track of all the discs in the magazine is played for 10 seconds each. Press and hold [BAND] (SCAN) again to cancel. Track number/Track playing time CD changer: Clock display Track Search Press and hold . . . [5TRACK]: Fast forward [6TRACK]: Fast backward Release to resume the regular CD or CD changer play. Disc number/Track number/ Track playing time Clock display Disc scan play CD changer 16 CQ-DFX501/DF401/DFX301U CQ-DFX501/DF401/DFX301U 17 E N G L I S H 9 Remote Control Unit Preparation Battery Installation 1 Remove the battery holder. Pull the holder by the position B while pushing position A in the direction indicated by the arrow. 2 Install the battery on the battery holder. This will help avoid confusion when making connections later. Note: Do not connect the power connector to the stereo unit until you have made all connections. If there are no plastic caps on the stereo hooking wires, insulate all exposed leads with electrical tape until you are ready to use them. Identify the leads in the following order. Power Lead If your car has a radio or is pre-wired for one: Cut the connector wires one at a time from the plug (leaving the leads as long as possible) so that you can work with individual leads. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for the battery, usually marked BAT. Speakers Identify the car speaker leads. There are two leads for each speaker which are usually color coded. A handy way to identify the speaker leads and the speaker they are connected with is to test the leads using a 1. 5 V AA battery as follows. Hold one lead against one pole of the battery and stroke the other lead across the other pole. You will hear a scraping sound in one of the speakers if you are holding a speaker lead. [. . . ] Turn off the car engine (ACC off) and remove the fuse from the battery lead (yellow) for 1 minute. Then reinstall the fuse. E N G L I S H 20 CD is inside but no sound. CD sound skips, tone quality is low. Sound skips due to vibration. CD Changer Display Only for CQ-DFX501/DF401U Cause/Step Disc is dirty, or is upside down. Press [RESET] on the CD changer (optional). Insert discs into the changer (magazine). CD is not ejected. DISC No. Sound Setting Trouble No sound from right, front or speakers. [. . . ]