User manual PANASONIC CQ-D55L

[. . . ] · CD-ROM, CD-RW playback · CD text display · MP3/WMA playback · Pause In principle, CD-R disc play is supported but it does not follow that it will be possible to play all such discs properly. CD changer mode display Disc number Track number Using Two Changers (Dual Changers) Use the dual changer control unit (CA-CD55; option) to connect the 2 CD changers to this unit. lights. E N G L I S H Scan Play Press [5]. The first 10 seconds of each track on all discs plays in sequence. 18 Press [5] again to cancel. lights. [. . . ] If normal operation is not restored, call the store where you purchased the unit or the nearest Servicenter to ask for repairs. MP3/WMA When there is no MP3/WMA files in the specified folder during direct MP3/WMA folder selection. Select another folder which contains MP3/WMA files. The player for some reason cannot read the file you are trying to play. (File recorded in an unsupported file system, compression scheme, data format, file name extension, damaged data, etc. ) Select a file that the player can read. Confirm the type of data recorded on the disc. Create a new disc if necessary. WMA An attempt has been made to play a copy-protected WMA file. Play WMA files which are not copy-protected. No disc is in the player. Insert a disc into the player. 46 CQ-D55L CQ-D55L 47 E N G L I S H 33 Troubleshooting (continued) CD Changer Display Cause/Step Disc is dirty, or is upside down. A disc other than a music CD (CD-DA type) is loaded. (The changer automatically switches to the next disc. ) Maintenance Notes on CD-Rs/RWs You may have trouble playing back some CD-R/RW discs recorded on CD recorders (CD-R/RW drives), either due to their recording characteristics or dirt, fingerprints, scratches, etc. CD-R/RW discs are less resistant to high temperatures and high humidity than ordinary music CDs. It does not contain warnings or cautions of potential dangers involved in attempting to install this product. Any attempt to install this product in a motor car by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death. The first step in installation is to identify all the car wires you'll use when hooking up your sound system. As you identify each wire, we suggest that you label it using masking tape and a permanent marker. This will help avoid confusion when making connections later. Note: Do not connect the power connector to the stereo unit until you have made all connections. If there are no plastic caps on the stereo hooking wires, insulate all exposed leads with electrical tape until you are ready to use them. Identify the leads in the following order. Power Lead If your car has a radio or is pre-wired for one: Cut the connector wires one at a time from the plug (leaving the leads as long as possible) so that you can work with individual leads. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for the battery, usually marked BAT. Speakers Identify the car speaker leads. There are two leads for each speaker which are usually color coded. A handy way to identify the speaker leads and the speaker they are connected with is to test the leads using a 1. 5 V AA battery as follows. [. . . ] (page 40) 2 Pull out. 4 Remove the unit pulling with both hands. 54 Caution: This face plate is not waterproof. Do not expose it to water or excessive moisture. Do not remove the face plate while driving your car. Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level. Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts. [. . . ]