User manual PANASONIC CQ-DF203W

[. . . ] E N G L I S H 11 Audio Settings (ATT) E N G L I S H 12 PWR MUTE MODE VOL PRG BAND/DISC UP [VOL "] [VOL #] (set) 1 Press [SEL] (select). (Push. ) 2 Turn [VOL]. [VOL #] [VOL "] TUNE TRACK Car Audio (Press [VOL "] or [VOL #] on the remote control unit. ) Select Note: Press [DISP] (display) to return to the regular mode. If no operation takes place for more than 7 seconds in audio setting, the display returns to the regular mode. Volume Default: 18 Setting range: 0 to 40 [VOL "]: Increases the volume. [VOL #]: Decreases the volume. Select Bass and Treble You can adjust the bass and treble sound. Default: BAS (bass) 0 dB TRE (treble) 0 dB Setting range: j12 dB to i12 dB (by 2 dB) Select [VOL "]: Increases the bass. [. . . ] <Right> <Wrong> Product Servicing If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized Panasonic service station. The product should be serviced only by a qualified technician. Do not attach any seals or labels to your discs. Do not write on the disc label in a heavy pen or ballpoint pen stroke. 28 CQ-DF203W CQ-DF203W 29 E N G L I S H 21 Installation Guide WARNING This installation information is designed for experienced installers and is not intended for non-technical individuals. It does not contain warnings or cautions of potential dangers involved in attempting to install this product. Any attempt to install this product in a motor car by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death. Identify All Leads The first step in installation is to identify all the car wires you'll use when hooking up your sound system. As you identify each wire, we suggest that you label it using masking tape and a permanent marker. This will help avoid confusion when making connections later. Note: Do not connect the power connector to the stereo unit until you have made all connections. If there are no plastic caps on the stereo hooking wires, insulate all exposed leads with electrical tape until you are ready to use them. Identify the leads in the following order. Power Lead If your car has a radio or is pre-wired for one: Cut the connector wires one at a time from the plug (leaving the leads as long as possible) so that you can work with individual leads. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for the battery, usually marked BAT. Speakers Identify the car speaker leads. There are two leads for each speaker which are usually color coded. A handy way to identify the speaker leads and the speaker they are connected with is to test the leads using a 1. 5 V AA battery as follows. Hold one lead against one pole of the battery and stroke the other lead across the other pole. You will hear a scraping sound in one of the speakers if you are holding a speaker lead. If not, keep testing different lead combinations until you have located all the speaker leads. When you label them, include the speaker location for each. The wiring diagram (page 36) shows the proper connections and color coding of the leads. We strongly recommend that you test the unit before making a final installation. You can set the unit on the floor and make temporary connections to test the unit. Use electrical tape to cover all exposed wires. [. . . ] This function is activated when the security function is on. (page 22) Caution: This face plate is not waterproof. Do not expose it to water or excessive moisture. Do not remove the face plate while driving your car. [. . . ]