User manual PANASONIC CQ-DF501

[. . . ] CD Player/Receiver with Changer Control CQ-DF501/DF301W SCAN AUTO·P REMOTE CQ-DF501W MOSFET 45WX4 OPEN RANDOM VOL SEL BAND TUNE TRACK S·HDB CD RECEIVER WITH CHANGER CONTROL REP PWR SOURCE Operating Instructions MONO/LOC MUTE 7 1 8 2 9 3 10 4 11 5 12 6 CLOCK DISP LEVL DIMMER (CQ-DF501W) Please read these instructions carefully before using this product and save this manual for future use. E N G L I S H Panasonic welcomes you to our ever growing family of electronic product owners. We know that this product will bring you many hours of enjoyment. Our reputation is built on precise electronic and mechanical engineering, manufactured with carefully selected components and assembled by people who take pride in their work. Once you discover the quality, reliability, and value we have built into this product, you too will be proud to be a member of our family. Use this Product Safely When Driving Keep the volume level low enough to be aware of road and traffic conditions. Disc Mechanism Do not insert coins or any small objects. [. . . ] Lower or higher impedance speakers will affect output and can cause both speaker and stereo unit damage. Motor Antenna Connect the car motor antenna lead to the dark blue motor antenna relay control lead. Battery Connect the yellow battery lead to the correct radio wire or to the battery fuse port on the fuse block. Antenna Connect the antenna by plugging the antenna lead into the antenna receptacle. Equipment Connect any optional equipment such as an amplifier, according to the instructions furnished with the equipment. Leave about 30 cm of distance between the speaker leads/amplifier unit and the antenna/antenna extension cord. Read the operating and installation instructions of any equipment you will connect to this unit. Power Connect the red power lead to the correct car radio wire or to the appropriate fuse port on the fuse block. If the stereo unit functions properly with all these connections made, disconnect the wires and proceed to the final installation. Final Checks 1. Make sure that all wires are properly connected and insulated. Make sure that the stereo unit is securely held in the mounting collar. Turn on the ignition to check the unit for proper operation. If you have difficulties, consult your nearest authorized professional installer for assistance. E N G L I S H 12 Preparation We strongly recommend that you wear gloves for installation work to protect yourself from injuries. When bending the mounting tabs of the mounting collar with a screwdriver, be careful not to injure your hands and fingers. Disconnect the cable from the negative - battery terminal (see caution below). Unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30o. Turn the ignition on to the accessory position, and ground one lead of the test bulb to the chassis. Touch the other lead of the test bulb to each of the exposed wires from the cut radio connector plug. Touch one wire at a time until you find the outlet that causes the test bulb to light. If the bulb also turns off and on, that outlet is the car power lead. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for radio (RADIO), accessory (ACC), or ignition (IGN). Battery Lead If your stereo unit has a yellow lead, you will need to locate the car's battery lead. Otherwise you may ignore this procedure. [. . . ] Press [RESET] on the CD changer (optional). Insert discs into the changer (magazine). Notes: There may be cases where the disc numbers affected by an error are displayed before "E1" or "E2". Displays and the steps to be taken for errors vary in part from changer to changer. [. . . ]