User manual PANASONIC CQ-DFX403U

[. . . ] These limits are designed to provide reasonable protection against harmful interference in an automobile installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio reception, which can be determined by turning the equipment off and on, the user is encouraged to consult the dealer or an experience radio technician for help. [. . . ] FM broadcast: Press [M/L] (MONO/LOC) to change the mode. AM broadcast: Press [M/L] (MONO/LOC) to switch LOCAL mode on and off. LOCAL MONO OFF/ LOCAL OFF MONO ON/ LOCAL OFF MONO ON/ LOCAL ON MONO OFF/ LOCAL ON MONO LOCAL 3 Tuning in a Preset Station Press the corresponding preset button [1] to [6] to tune in a preset station. Note: You can change the memory presetting by repeating the above procedure. MONO LOCAL MONO LOCAL AM broadcast: MONO LOCAL LOCAL OFF LOCAL ON CQ-DPX151/DP101U MONO LOCAL 14 CQ-DPX151/DP101U 15 E N G L I S H 7 CD Player Basics Caution: Only 12 cm CD is available for this unit. Track Selection < (EJECT) [5TRACK]: Advance to the next track. [6TRACK]: Back to the beginning of the current track. (Press twice. ) Track Search Press and hold . . . [5TRACK]: Fast forward [6TRACK]: Fast backward Release to resume the regular CD play. E N G L I S H 8 Disc Insert and Playback Disc insert Playback will start automatically. "LOAd" will be displayed until the disc is loaded. < Direct Track Selection Label side Press a track number button from [1] to [6]. Press and hold a track number button from [7] to [12] ([1] to [6]) for more than 1 second. The corresponding track starts playing. When CD is in the player Press [SOURCE] to change to CD play mode. SCAN/APM RANDOM Stop and Disc Eject Press [<] (EJECT) to stop CD play and eject the disc. During disc ejection, "EJ" (EJECT) will be displayed. 10 RANDOM VOL SEL BAND TUNE TRACK DISP MUTE CQ-DPX151U CD RECEIVER 45WX4 < PWR REMOTE REP SOURCE LOUD CD RECEIVER 45WX4 DISC < PWR REP SOURCE LOUD 7 1 8 2 9 3 10 4 11 5 12 6 M/L MONO /LOC TRACK REMOTE 11 12 Lights when the disc is loaded. Scan play Listening to a CD Display Change Press [DISP] (DISPLAY) to switch to the clock display. DISC Random play Repeat play Mode Selection Press [SOURCE] to change to the CD play mode. Source Radio Random play CD player (When a CD is inserted. ) TRACK Press and hold [REP] (RANDOM) for more than 2 seconds. You will hear the antenna motor activate when you touch the correct wire. Antenna The antenna lead is a thick, black wire with a metal plug at the end. E N G L I S H 10 Installation Hardware No. 1 2 3 4 5 6 7 8 Item Mounting collar Hex. nut (5 mm·) Rear support strap Tapping screw (5 mm·a16 mm) Mounting bolt (5 mm·) Power connector Removable face plate case Trim plate Diagram Q'ty 1 1 1 1 1 1 1 1 If you encounter problems, please consult your nearest professional installer. Caution: This unit operates with a 12 V DC negative ground auto battery system only. Do not attempt to use it in any other system. Before you begin installation, look for the items which are packed with your unit. Warranty Card. . . Fill this out promptly. Panasonic Servicenter for Service Directory . . . Keep for future reference in case the product needs servicing. Installation Hardware. . . Needed for in-dash installation. Turn the ignition on to the accessory position, and ground one lead of the test bulb to the chassis. Touch the other lead of the test bulb to each of the exposed wires from the cut radio connector plug. [. . . ] Place CD in the correct direction, and the label side up. Clean CD, referring to the section on "Notes on CD". Clean CD, referring to the section on "Notes on CD". Mount the unit securely with the mounting parts, referring to the section on installation. [. . . ]