User manual PANASONIC CQ-DFX77EUC

[. . . ] It is important that you fully understand the meanings of the pictographs in order to use this manual and the system properly. Warning This pictograph intends to alert you to the presence of important operating instructions and installation instructions. Failure to heed the instructions may result in severe injury or death. Caution This pictograph intends to alert you to the presence of important operating instructions and installation instructions. Failure to heed the instructions may result in injury or material damage. Warning Observe the following warnings when handling this unit. The driver should not operate the system while driving. Operating the system will distract the driver from looking ahead of the vehicle and can cause accidents. Always stop the vehicle in a safe location and use the parking brake before operating the system. Observe the following warnings when installation. Disconnect the lead from the negative (­) battery terminal before installation. Wiring and installation with the negative (­) battery terminal connected may cause electrical shock and injury due to a short circuit. [. . . ] After checking your XM Satellite Radio ID, sign up on the XM's website or by calling them. q Check of XM Satellite Radio ID · Write down the ID indicated on the lower right of your XM receiver (XM-RVR-FM-001, option). XMD 1000 L/C 1144XXXXXX XM RADIO ID : XXXXXXXX XM RADIO ID · Check the ID shown by tuning your XM Radio to channel 0. (Refer to "XM ID Confirmation" on page 25). RADIO ID display (Example) w Activate the XM Satellite Radio Select either of the below to sign up · Web site: http://www. xmradio. com/activation · Phone number: 1-800-852-9696 22 CQ-DFX77EUC Preparation: Connect the XM receiver (XM DIRECT MODEL:XM-RVR-FM-001) to the Unit CQ-DFX77EUC. XM satellite radio is available on a chargable basis. w Band Press [BAND]. q XM Mode (When a XM receiver is connected. ) Press [SRC] to change to the XM mode. [CATEGORY] e Channel Selection · Manual Tuning Press [}TUNE]: Up Press [{TUNE]: Down · Seek Tuning Press and hold for more than 0. 5 seconds and release it. [}SEEK]: Up [{SEEK]: Down Tuning will automatically stop when the next broadcast station is received. Note: Tuning will change into the ID confirmation display when selecting channel 0. XM displays as follows, (Example) after 2 seconds Satellite Radio Indicator Preset Number Channel Number after 5 seconds XM Band Channel Name Category Priority Setting and Selecting *You can toggle the category on and off every time you hold down [BAND] for 2 seconds. (when category is set ON. ) (press [BAND] for more than 2 seconds to set category ON. ) (when category is set ON. ) (after 2 seconds) (press [BAND] for more than 2 seconds to set category OFF. ) (when category is set OFF. ) (after 2 seconds) 23 CQ-DFX77EUC XM Control (Continued) · When the display shows "CATEGORY", Press [2] (}): Up Press [1] ({): Down Press [1] or [2]. (After 2 seconds. ) Category Name Press [1] or [2]. Category Name (After 5 seconds. ) category ON indicator Notes: CAT OFF: Every channel can be selected from every category. CAT ON: Only channels in the current category can be selected. Default: CAT OFF Manual Preset Memory Up to 6 channels each can be saved in the XM1, XM2 and XM3 preset station memories. q Select a band and a channel. TUNE SEEK w Press and hold [1] to [6] for more than 2 seconds to memorize. · The channel number and the preset number blink once. There is no Sirius Satellite coverage in Canada. The instruction of Satellite Operation controls in the Operating Instructions and Guide will not be applied. w Band Press [BAND]. q Sirius Mode (When a Sirius receiver is connected and Sirius setting is SET ON. ) Press [SRC] (source) to change to the Sirius mode. [CATEGORY] e Channel Selection · Manual Tuning Press [}TUNE]: Up Press [{TUNE]: Down · Seek Tuning Press and hold for more than 0. 5 seconds and release it. [}SEEK]: Up [{SEEK]: Down Tuning will automatically stop when the next broadcast station is received. Note: Tuning will change into the ID confirmation display when selecting channel 0. Sirius control mode display (Example) after 2 seconds Satellite Radio Indicator Preset Number Channel Number after 5 seconds Sirius Band Channel Name Category Priority Setting and Selecting You can toggle the category on and off every time you hold down [BAND] for 2 seconds. (when category is set ON. ) (press [BAND] for more than 2 seconds to set category ON. ) (when category is set ON. ) (after 2 seconds) (press [BAND] for more than 2 seconds to set category OFF. ) (when category is set OFF. ) (after 2 seconds) 27 CQ-DFX77EUC Sirius Control (Continued) · When the display shows "CATEGORY", Press [2] (}): Up Press [1] ({): Down Press [1] or [2]. (After 2 seconds. ) Category Name Press [1] or [2]. Category Name (After 5 seconds. ) category ON indicator Notes: CAT OFF: Every channel can be selected from every category. CAT ON: Only channels in the current category can be selected. Default: CAT OFF Manual Preset Memory Up to 6 channels each can be saved in the SR1, SR2 and SR3 preset station memories. q Select a band and a channel. TUNE SEEK w Press and hold [1] to [6] for more than 2 seconds to memorize. · The channel number and the preset number blink once. Note: Existing saved channels are overwritten with new channels after the above procedure. Preset memory Calling q Select a band. w Press [1] to [6]. Note: When category is on category will be off after pressed any preset button [1] to [6]. 28 CQ-DFX77EUC Display Change Press [DISP] to change the display. a Sirius band display (Reading channel name) Channel name (Reading artist name) Artist name (Reading song title) song title (Reading composer name) Composer name Note: ¡ "ADJUST" is displayed when the clock is not adjusted. [. . . ] FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVATION OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY. · Disconnect the cable from the negative terminal (see warning and caution below). battery · Remove Mounting Collar q from the main unit temporarily, which are already mounted at shipment. * Caution Various settings that have been stored in the memory in other on-board equipment (vehicle navigation etc. ) may be lost if the battery terminals are disconnected. Therefore, we recommend to make a record of or to back up the settings before disconnecting the terminals. [. . . ]