User manual PANASONIC CQ-DP800L

[. . . ] DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL. Safety Information . 24 E N G L I S H çÄ êìëëäéå üáõäÖ 2 CQ-DP800L CQ-DP800L 3 ëÓÂÊÌË ëÚÌË^ àÌÙÓÏ^Ëfl Îfl ·ÂÁÓÔÒÌÓÒÚË . 2 ëÓÂÊÌËÂ. [. . . ] Instead take extra care with installing the unit to prevent shorts. y u i q Mounting Collar Dashboard Installation Installation Opening The unit can be installed 53 mm in any dashboard having an opening as shown at 182 mm right. The dashboard should be 4. 5 mm - 6 mm thick in order to be able to support the unit. Installation Precautions This product should be installed by a professional installer, if possible. In case of difficulty, please consult your nearest authorized Panasonic Service Center. This system is to be used only in a 12-volt, DC battery system (car) with negative ground. Follow the electrical connections carefully (a page 16). Failure to do so may result in damage to the unit. Connect the power lead (red) after all other connections are made. Be sure to connect the battery lead (yellow) to the positive terminal (+) of the battery or fuse block (BAT) terminal. Insulate all exposed wires to prevent short circuiting. · Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep cable terminals free from touching any metal parts. · Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when the battery terminals are disconnected. Speaker Connections Caution: Please follow the instructions given below. Failure to do so will cause damage to the unit and speakers. <Right> L+ (White) + - E N G L I S H 12 (White w/black stripe) (Gray) R+ - + - Wiring Diagram Preamp output connector (rear) (Gray w/black stripe) · Use ungrounded speaker only. · The maximum speaker input should be 45 W or more. (If used with the optional power amplifier, the speaker input should be higher than the maximum amplifier output. ) · The speaker impedance should be 4 - 8 . · This unit uses the BTCL circuit, so each speaker should be connected separately using parallel vinyl insulated cords. · The speaker cords and the power amplifier unit should be kept away (about 30 cm apart) from the antenna and antenna extension cord. <Wrong> Fuse (15 A) C L+ + - CQ-DP800L L (White) R (Red) Antenna C If the fuse (rear panel) blows frequently, they may L+ - + - L+ - + - + - y Power connector Ground lead To a clean, bare metallic part of car chassis. Motor antenna relay control lead (To motor antenna) (Max. 500 mA) This lead is not intended for use with switch actuated power antenna. Note: The power antenna extends automatically when the FM/AM radio mode is selected. be something wrong with the unit. [. . . ] Sound skips due to vibration. CD (Continued) Trouble Cause/Step Mounting angle is over 30°. Adjust mounting angle to less than 30°. Mount the unit securely with the mounting parts, referring to the section on installation. If normal operation is not restored, call the store where you purchased the unit. [. . . ]