User manual PANASONIC CQ-DRX901U

[. . . ] ® Removable Front CD Player/Receiver with DSP and CD Changer Control Lecteur de CD avec façade amovible - récepteur avec DSP et commande de changeur CD CQ-DRX901U CD RECEIVER WITH DSP & CHANGER CONTROL Human Equalizer MOSFET 45Wx4+5 OPEN TILT BAND APM HIGH ENERGY ENERG Neodymium Magnet Center Speaker SPEAKER -HEQ -BAL/FAD OPEN/CLOSE MUTE -POSI -GEQ POWER Reproductor de CD/receptor con DSP y control de cambiador de CD de panel frontal extraíble SOURCE TUNE P· SET DISP REMOTE VOL SEL TRACK DISC D CQ-DRX901U Operating Instructions Manuel d'instructions Manual de instrucciones Instrucciones ¡Please read these instructions carefully before using this product and save this manual for future use. ¡Prière de lire ces instructions attentivement avant d'utiliser le produit et garder ce manuel pour l'utilisation ultérieure. ¡Lea con atención estas instrucciones antes de utilizar el producto y guarde este manual para poderlo consultar en el futuro. E N G L I S H Safety Information Radio Frequency Interference Statement (Part 15 of the FCC Rules) : Applies only in U. S. A. This equipment has been tested and found to comply with the limits for a Class B digital, pursuant to Part 15 of the FCC Rules. ¡These limits are designed to provide reasonable protection against harmful interference in an automobile installation. [. . . ] External input (AUX-IN) is not selectable as a source. AUX-IN SET With AUX-IN set to OFF, AUX-IN will not be selected when [SOURCE] is pressed. (a page 12 about source selection) Select [[] : S-LED On The indicator blinks when the panel is removed. The indicator does not blink when the panel is removed. S-LED SEL []] : S-LED Off Select [[] : TILT On Panel angle can be adjusted. Panel angle cannot be adjusted. TILT SELECT []] : TILT Off CQ-DRX901U 33 E N G L I S H 24 Installation Guide WARNING This installation information is designed for experienced installers and is not intended for non-technical individuals. It does not contain warnings or cautions of potential dangers involved in attempting to install this product. Any attempt to install this product in a motor car by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death. Overview This product should be installed by a professional. However, if you plan to install this product yourself, your first step is to decide where to install it. The instructions in these pages will guide you through the remaining steps: (Please refer to the "WARNING" statement above). ¡Identify and label the car wires. ¡Connect the car wires to the wires of the power connector. If you encounter problems, please consult your nearest professional installer. Installation Hardware No. q Item Diagram Q'ty 1 Mounting Collar Mounting Bolt (5 mmø) Power Connector Removable Face Plate Case Trim Plate Rear support strap Tapping screw Hex. Nut w 1 e 1 r 1 t 1 y 1 u 1 Caution: This unit operates with a 12 volt DC negative ground auto battery system only. Do not attempt to use it in any other system. Doing so could cause serious damage. i 1 Required Tools Before you begin installation, look for the items on the right which are packed with your unit. ¡Warranty Card. . . . . . . . . . . . . . . . . . . . Fill this out promptly. ¡Panasonic Service center for Service Directory. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Keep for future reference in case the product needs servicing. ¡Installation Hardware . . . . . . . . Needed for in-dash installation. You'll need a screwdriver, a 1. 5 volt AA battery, and the following: 12 V DC Test Bulb Electrical Tape Side-Cut Pliers 34 CQ-DRX901U Dashboard Specifications Thickness Min. 7/32" (5. 56 mm) 2-3/32" (53 mm) Battery Lead If your stereo unit has a yellow lead, you will need to locate the car's battery lead. Otherwise you may ignore this procedure. (The yellow battery lead provides continuous power to maintain a clock, memory storage, or other function. ) If your car has a radio or is pre-wired for one: With the ignition and headlights off, identify the car battery lead by grounding one lead of the test bulb to the chassis and checking the remaining exposed wires from the cut radio connector plug. [. . . ] Direct the remote controller at REMOTE (sensor) on the panel. 44 CQ-DRX901U Error Display Messages 3CD Example of Display CD |E 1 | Cause Disc is dirty, or is upside down. Disc has scars. E N G L I S H 35 Operation May be automatically ejected. Check/Step Check disc. CD |E 2 | CD |E 3 | No operation by some cause -- Open the panel and press [u]. If failure persists, press the reset switch. If normal operation is not restored yet, call and ask for repairs. PLS EJECT Action was taken to start playing before disc is fully ejected. -- Open the panel and press [u]. 3Changer Example of Display CD¥CH |E 1 | Cause Disc is dirty, or is upside down. Disc has scars. Operation May be automatically ejected. Check/Step Check disc. CD¥CH |E 2 | CD¥CH |E 3 | No operation by some cause -- Open the panel and press [u]. If failure persists, press the reset switch. [. . . ]