User manual PANASONIC CQ-HR1003U

[. . . ] E N G L I S H 17 CD Changer Control CD changer functions are designed for optional Panasonic CD changer unit. Preparation: Connect the CD changer, and load a magazine (CDs). Note: The power will be turned on automatically when a magazine is loaded. The following functions are not supported during playback through a CD changer: · CD-ROM, CD-RW playback · CD text display · Pause · MP3/WMA playback In principle, CD-R disc play is supported but it does not follow that it will be possible to play all such discs properly. Direct Disc Selection Example: disc number 10 Display Change Press DISPLAY /[DISP] (display). [. . . ] Check the disc. The changer has become disconnected from the main unit in the changer mode. Verify that correct connections have been made. Note: For details, refer to operating instructions for the changer used. No operation by some cause. If normal operation is not restored, call the store where you purchased the unit or the nearest Servicenter to ask for repairs. When there is no MP3/WMA files in the specified folder during direct MP3/WMA folder selection. Select another folder which contains MP3/WMA files. The player cannot read the file you are trying to play for some reason. (File recorded in an unsupported file system, compression scheme, data format, file name extension, damaged data, etc. ) Select a file that the player can read. Confirm the type of data recorded on the disc. An attempt has been made to play a copy-protected WMA file. Play WMA files which are not copy-protected. 60 CQ-HX1083/HR1003U CQ-HX1083/HR1003U 61 E N G L I S H 35 Troubleshooting (Continued) If the Unit does not Operate Properly Reset switch Push a thin, unbreakable object into this hole to press the reset switch. After a reset, the unit reverts to its initial state. Note that any information or settings stored in the unit's memory will be lost. Caution: Press the reset switch if pressing any of the other buttons has no effect. Maintenance Clean Touch Panel by Wiping Lightly with a Soft Cloth Before cleaning, turn off in the ignition or remove the front panel. When the top surface of the touch panel has become dirty, use the included wiping cloth to wipe the surface thoroughly. Under no circumstances should detergents or other such cleaning substances be used for this purpose. Do not allow the top surface of the touch panel to be caught by your fingernails or any hard objects. If you do so, you may damage or break the glass on the top surface of the touch panel. Notes on CD/CD Media (CD-ROM, CD-R, CD-RW) If you use commercial CDs, they must have either of these labels below. E N G L I S H 36 Maintenance Your product is designed and manufactured to ensure a minimum of maintenance. Use a dry, soft cloth for routine exterior cleaning. Never use benzine, thinner or other solvents. Replacing the Fuse Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting the unit directly without a fuse, could cause fire or damage to the unit. If the replacement fuse fails, contact your nearest Panasonic Servicenter for service. How to hold the disc Do not touch the underside of the disc. [. . . ] Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level. Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts. If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth. To avoid damaging the front panel, do not push it down or place objects on it while it is open. CQ-HX1083/HR1003U CQ-HX1083/HR1003U 69 E N G L I S H 43 Electrical Connections Caution: This product is designed to operate with a 12 V DC, negative ground battery system. [. . . ]