User manual PANASONIC CQ-HX2083U

[. . . ] E N G L I S H 21 Front Panel Settings [COLOR] 1 1 2 Press. Press. 2 (Example: STORM) 3 E N G L I S H (Example: PATTERN 1) For details on how to perform menu operations using the remote control, refer to page 28. Note: Press [MENU] or [DISP] (display) on the remote control to return to the regular mode. Press /[RET] (RETURN) to return to the previous display. 22 1 Menu Display Color Changing Pattern (STORM) This is used to select the pattern that changes the colors of the display area. [. . . ] Use a dry, soft cloth for routine exterior cleaning. Never use benzine, thinner or other solvents. Replacing the Fuse Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting the unit directly without a fuse, could cause fire or damage to the unit. If the replacement fuse fails, contact your nearest Panasonic Servicenter for service. How to hold the disc Do not touch the underside of the disc. When not in use, keep the disc in the case. Label side Product Servicing If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized Panasonic Servicenter. The product should be serviced only by a qualified technician. Do not use irregular shaped discs. Notes on CD-Rs/RWs You may have trouble playing back some CDR/RW discs recorded on CD recorders (CD-R/RW drives), either due to their recording characteristics or dirt, fingerprints, scratches, etc. CD-R/RW discs are less resistant to high temperatures and high humidity than ordinary music CDs. Leaving them inside a car for extended periods may damage them and make playback impossible. The unit may not successfully play back a CDR/RW that was made by the combination of writing software, a CD recorder (CD-R/RW drive) and a disc if they are incompatible one another. This player cannot play the CD-R/RW discs if the session is not closed. This player cannot play the CD-R/RW discs which contains other than CD-DA (or MP3/WMA data). Be sure to observe the instructions of CD-R/RW disc for handling it. Do not leave discs on the following places: Direct sunlight Near car heaters Dirty, dusty and damp areas Seats and dashboards Disc cleaning Use a dry, soft cloth to wipe from the center outward. <Right> <Wrong> Do not attach any seals or labels to your discs. Do not write on the disc label in a heavy pen or ballpoint pen stroke. 62 CQ-HX2083U CQ-HX2083U 63 E N G L I S H 37 Installation Guide WARNING This installation information is designed for experienced installers and is not intended for non-technical individuals. It does not contain warnings or cautions of potential dangers involved in attempting to install this product. Any attempt to install this product in a motor car by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death. Dashboard Specifications Thickness Min. 7/32z (5. 56 mm) 23/32z (53 mm) 75/32z (182 mm) Identify All Leads The first step in installation is to identify all the car wires you'll use when hooking up your sound system. As you identify each wire, we suggest that you label it using masking tape and a permanent marker. This will help avoid confusion when making connections later. Note: Do not connect the power connector to the stereo unit until you have made all connections. If there are no plastic caps on the stereo hooking wires, insulate all exposed leads with electrical tape until you are ready to use them. [. . . ] Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level. Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts. If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth. To avoid damaging the front panel, do not push it down or place objects on it while it is open. CQ-HX2083U CQ-HX2083U 69 E N G L I S H 43 Electrical Connections Caution: This product is designed to operate with a 12 V DC, negative ground battery system. [. . . ]