User manual PANASONIC CQ-R221W

[. . . ] Operating Instructions High-Power Cassette Player/Receiver with Changer Control CQ-R221W R · Please read these instructions carefully before using this product and save this manual for future use. · E N G L I S H Contents Page Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Power and Sound Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Radio Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If a loose tape is used, this may result in the tape becoming tangled in the rotating parts of the unit. Pencil Do not touch or pull out the tape. Notes: q To maintain your cassette player in top condition, avoid using tapes that are longer than 90 minutes (C-90). q If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a finger or the like, the cassette may not be properly reproduced. In such a case, eject the cassette, make the tape tight, then insert it back into the deck. 10 CQ-R221W CD Changer Basics Note: CD changer functions are applicable to units with optional CD changer unit. Displays when the compact disc stops operating for some reason. Please contact your nearest authorized Panasonic Servicenter. Displays when there is no disc in the magazine. 12 CQ-R221W Clock Basics (The clock system is 12-hours. ) CQ-R221W E N G L I S H 10 S·HDB Press and hold Initial Time Setting Press and hold [DISP] for more than 2 seconds. Press and hold [DISP] again for more than 2 seconds. "12" blinks indicating the time setting mode is activated. j i CQ d Press again [DISP] for minute setting. j i Hold [j] or [i] to change numbers j i rapidly. When you have set the time, press [DISP]. S·HDB d Press and hold Resetting the Time When you want to reset the time, press and hold [DISP] for more than 2 seconds to activate the time setting mode. Then, repeat step to above. Selecting the Clock Display Press [DISP] for clock display. Press [DISP] once again, the current audio display mode resumes. 13 CQ-R221W E N G L I S H 11 Remote Control Unit Preparation Battery Installation Remove the battery holder. Take hold of the holder at position B and pull it out by pushing position A in the direction shown by the arrow. Install the battery on the battery holder. Set a new battery properly with its (+) side facing up as shown in the figure. Push in the battery holder back into its original position. Position B (Back side) Lithium battery Battery Notes Remove and dispose of an old battery immediately. Battery information: q Battery Type: Panasonic lithium battery (CR2025) (Included) q Battery Life: Approximately 6 months under normal use (at room temperature) Position A Battery holder Caution: Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire. Do not disassemble or short the battery. Keep batteries away from children to avoid the risk of accidents. q Be careful to the disposal rules when you dispose of batteries. q q Remote Control (ATT) Power Mode (Source) PWR MUTE Mute MODE VOL Volume Control Band/Disc up, program, STOP PRG BAND/DISC UP TUNE TRACK Tune, Track Search, Fast Forward/Rewind Car Audio 14 CQ-R221W Installation Guide Preparation Before installation, check the radio operation with antenna and speakers. [. . . ] If the impedance is too large or too small, it affects the output and may cause damage to the speakers or this unit. Do not use 3-wire type speaker system having a common earth lead. Never connect the speaker cord to the body of the car. This unit uses the BTCL circuit, so each speaker should be connected separately using parallel vinyl insulated cords. [. . . ]