User manual PANASONIC CQ-RD325LEN

[. . . ] 6 Casssette Tape Player Basics . . . . . . . . . . . . . . . . . . . . . . 8 CD Changer Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Clock Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Remote Control Unit Preparation. . . . . . . . . . . . . . . . . [. . . ] To turn it off, press [1] (MTL) again. S·HDB Note: Playing non-metal tapes in metal tape mode causes high frequency imbalance, which affects tone quality. CQ-RD325LEN Dolby Noise Reduction Press [2] (NR) to set the Dolby B NR mode. S·HDB To cancel the Dolby B NR mode, press [2] (NR) again. Note: Set the Dolby B NR mode when playing back a tape recorded with Dolby B Noise Reduction. 9 CQ-RD325LEN E N G L I S H 7 Cassette Tape Player Basics (continued) 21W TPS Operation (Tape Program Search) Press [3] (TPS) to activate the tape program search mode. d CQ From the current selection, decide which program you want to select. Now, press [ ] several times forward (up to 9 programs) or press [ ] several times backward (up to 8 ) to select the corresponding program number. (Rewind:) 8 0 c (Fast forward:) 1 9 c S·HDB or CQ S·HDB EX1. To select the current program again press [3] (TPS), and press [ ] once. To select the 1st program backward of the current selection, press [3] (TPS) once, and press [ ] two times. To select the next program, press [3] (TPS) and press [ ] once. To select the 3rd program forward of the current selection, press [3] (TPS) once, and press [ ] three times. To turn it off, press [3] (TPS) again. Note: The TPS mode may not work correctly in the following cases. This, however, does not mean that the unit is defective. q There is an interval less than 4 seconds or having a high level of noise or hum between programs. For this type of car, battery could not be disconnected. Therefore, extra care should be taken to prevent short circuitting. In-dash Installation Installation Opening In-dash installation can be done if the car's dashboard has an opening for this unit as shown in Fig. The car's dashboard should have a thickness of 4. 5 mm - 6 mm in order to make the installation of the unit. 53 mm 182 mm Fig. 1 Installation Precautions This equipment, if possible, should be installed by a professional installer. In case of difficulty, please consult your nearest authorized Panasonic Service Center. This system is to be used only in a 12-volt, DC battery system (car) with negative ground. Follow the electrical connection on page 20 carefully. Failure to do so may result in damage to the unit. Connect the power lead after other connections are made. Be sure to connect the YELLOW lead to the positive terminal (+) of the battery or fuse block (BAT) terminal. Insulate all exposed wires to prevent short circuitting. [. . . ] The speakers to be used with this unit should be able to handle more than 40 W of audio power. If an optional amplifier is used, the speakers should be able to handle the maximum output power of the amplifier. Use of speakers with small input ratings can cause damage to the speakers. The speaker impedance should be 4 - 8 ohms. [. . . ]