User manual PANASONIC CQ-RD520

[. . . ] 6 Casssette Tape Player Basics . . . . . . . . . . . . . . . . . . . . . . 8 CD Changer Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Clock Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Installation Gudie . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If you press [u] (EJECT), the unit ejects the tape and returns to radio operation. When you stop the car engine, the tape will stop but not be ejected. Notes: q You can not change to CD Changer mode or Radio mode while tape is playing. If you want to change to CD Changer mode or Radio mode, eject the tape. q Always remove the cassette when you stop using the cassette player. This will prolong the life of your tape. E N G L I S H 6 Notes on Cassette Tapes Tape Slack: Use a pencil or similar object to take up the slack as shown. If a loose tape is used, this may result Pencil in the tape becoming tangled in the rotating parts of the unit. Do not touch or pull out the tape. Cautions: q To maintain your cassette player in top condition, avoid using tapes that are longer than 90 minutes (C-90). q If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a finger or the like, the cassette may not be properly reproduced. In such a case, eject the cassette, make the tape tight, then insert it back into the deck. 9 CQ-RD520 E N G L I S H 7 CD Changer Basics Note: CD changer functions are applicable to units with optional CD changer unit. (sold separately) CQ-RD520 LOUD To Changer mode While a disc magazine is inserted in the CD changer, press [CD·C]. Play starts from the first track. Play Time Disc Number Track Number Note: The cassette, if loaded, should be removed. step Selecting the Clock Display Press [DISP] for clock display. Press [DISP] once again, the current audio display mode resumes. 12 CQ-RD520 Installation Guide Preparation Before installation, check the radio operation with antenna and speakers. Disconnect the cable from the negative (­) battery terminal (see caution below). q Unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°. q q E N G L I S H 10 Caution: For installation to cars with trip or navigational computers, all electronic memory settings previously registered in the computer will be lost when the battery terminal is disconnected. For this type of car, battery could not be disconnected. Therefore, extra care should be taken to prevent short circuitting. In-dash Installation Installation Opening In-dash installation can be done if the car's dashboard has an opening for this unit as shown in Fig. The car's dashboard should have a thickness of 4. 5 mm - 6 mm in order to make the installation of the unit. 53 mm 182 mm Fig. 1 Installation Precautions This equipment, if possible, should be installed by a professional installer. In case of difficulty, please consult your nearest authorized Panasonic Service Center. This system is to be used only in a 12-volt, DC battery system (car) with negative ground. Follow the electrical connection on page 18 carefully. [. . . ] If an optional amplifier is used, the speakers should be able to handle the maximum output power of the amplifier. Use of speakers with small input ratings can cause damage to the speakers. The speaker impedance should be 4 - 8 ohms. If the impedance is too large or too small, it affects the output and may cause damage to the speakers or this unit. [. . . ]