User manual PANASONIC CS-A12HKD

[. . . ] Please consult an authorized dealer or specialist for the installation work. · Do not insert your fingers or other objects into the unit. · Do not attempt to repair the unit by yourself. Air inlet Indoor Unit · Do not install the unit in a potentially explosive atmosphere. · Do not wash the unit with water, benzene, thinner or scouring powder. [. . . ] · Do not install the unit in oily and smoky areas. 3 ENGLISH PRODUCT OVERVIEW & OPERATIONS PRODUCT OVERVIEW & OPERATIONS e-ion AIR PURIFYING SYSTEM Do not touch during operation e-ion filters Front panel Active e-ion Power Module Active e-ion Generator Auto OFF/ON button · Used when remote control is misplaced or malfunction. Press and hold until 1 beep is heard, then release. Mode Auto Cooling INDICATOR Horizontal airflow direction louver · Manually adjustable. (Green) (Orange) (Orange) (Orange) (Blue) um Vertical airflow direction louver · Do not adjust by hand. tan ce s: 8m Receiver TO TURN ON OR OFF THE UNIT · Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. TO SET TEMPERATURE · For heat, cool and dry modes, the range of temperature for selection is 16°C ~ 30°C. · Operating the unit within the recommended temperature could induce energy saving. DRY mode : 1°C ~ 2°C lower than room temperature. TO SELECT OPERATION MODE AUTO mode - For your convenience · Unit selects the operation mode according to the room temperature. · Once auto mode is selected, the unit will operate at the standard setting temperature. · To change the standard setting temperature, press for "HI" or for "LO". Room Operation Standard setting HI LO temperature mode temperature (+2°C) (-2°C) 23°C & above Cool 25°C 27°C 23°C Below 23°C Dry 22°C 24°C 20°C Below 20°C Heat 21°C 23°C 19°C HEAT mode - To enjoy warm air · In heat mode, it takes a while for the unit to warm up. The power indicator blinks during this operation. COOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. Remote control display 4 Ma xim dis · To turn ON or OFF the unit at a preset time. · For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. TO ADJUST VERTICAL AIRFLOW DIRECTION (5 OPTIONS) Select ON or OFF timer. or then · To cancel ON or OFF timer, press · Keeps the room ventilated. · If AUTO is set, the louvers swing up/down automatically. · In heat mode, the air blows horizontally for a while, then starts to blow downwards. TO ENJOY CLEAN & FRESH AIR · Generates negative ions to produce fresh air effect and attract dust which will then be captured at the positively charged e-ion filters. TO MONITOR AIR QUALITY · Patrol sensor detects air quality. · When air quality is at dirty level, e-ion operation will start automatically. QUITE POWERFUL press . · When ON Timer is set, the unit may start earlier (up to 30 minutes) before the actual set time in order to achieve the desired temperature on time. · Timer operation is based on the clock set in the remote control and repeats daily once set. For clock setting, please refer to Remote Control Preparation at back cover. · If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is . [. . . ] · Remove the remote control batteries. 6 TROUBLESHOOTING TROUBLESHOOTING The following symptoms do not indicate malfunction. Cause · Condensation effect due to cooling process. · Refrigerant flow inside the unit. · This may due to damp smell emitted by the wall, carpet, furniture or clothing. [. . . ]