User manual PANASONIC CS-C18HKD

[. . . ] Please consult an authorized dealer or specialist for the installation work. · Do not insert your fingers or other objects into the unit. · Do not attempt to repair the unit by yourself. Air inlet Indoor Unit · Do not install the unit in a potentially explosive atmosphere. · Do not wash the unit with water, benzene, thinner or scouring powder. [. . . ] TO SET TEMPERATURE Remote control display Ma xim · For cool and dry modes, the range of temperature for selection is 16°C ~ 30°C. · Operating the unit within the recommended temperature could induce energy saving. DRY mode : 1°C ~ 2°C lower than room temperature. TO SELECT OPERATION MODE AUTO mode - For your convenience · Unit selects the operation mode according to the room temperature. · Once auto mode is selected, the unit will operate at the standard setting temperature. · To change the standard setting temperature, press for "HI" or for "LO". Room temperature 23°C & above Below 23°C Operation mode Cool Dry Standard setting temperature 25°C 22°C HI LO (+2°C) (-2°C) 27°C 23°C 24°C 20°C COOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. 4 · To turn ON or OFF the unit at a preset time. · For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. TO ADJUST AIRFLOW DIRECTION (5 OPTIONS) Select ON or OFF timer. or then · To cancel ON or OFF timer, press press · Keeps the room ventilated. · If AUTO is set, the louvers swing left/right and up/down automatically. TO ENJOY CLEAN & FRESH AIR · Generates negative ions to produce fresh air effect and attract dust which will then be captured at the positively charged e-ion filters. TO MONITOR AIR QUALITY Indicator Air Quality · Patrol sensor detects air quality. Blue Clean · When air quality is at dirty Orange Moderate level, e-ion operation will start Red Dirty automatically. TO ENJOY QUIET ENVIRONMENT · This operation reduces airflow noise. TO ACHIEVE TEMPERATURE QUICKLY · This operation will stop automatically after 15 minutes. . · When ON Timer is set, the unit may start earlier (up to 15 minutes) before the actual set time in order to achieve the desired temperature on time. · Timer operation is based on the clock set in the remote control and repeats daily once set. For clock setting, please refer to Remote Control Preparation at back cover. · If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is resumed) by pressing . OPTIONAL SETTINGS Patrol starts automatically with the unit switched on with . Press and hold for 5 seconds, then release to disable or restore this setting. Press and hold for 5 seconds to dim or restore the unit's indicator brightness. [. . . ] Indoor fan stops occasionally during automatic · This helps to remove the surrounding odours. Operation is delayed a few minutes after · The delay is a protection to the unit's compressor. · Condensation or evaporation occurs on pipes. · The timer setting repeats daily once set. [. . . ]