User manual PANASONIC CS-CE12PKE

[. . . ] Indoor Unit Operating Instructions Air Conditioner 2-9 Outdoor Unit Thank you for purchasing this Panasonic Air conditioner. Before operating the unit, read these operating instructions thoroughly and keep them for future reference. Quick guide Inserting the batteries 1 Pull out the back cover of remote control 2 Insert AAA or R03 batteries (can be used ~ 1 year) 3 Close the cover Clock setting 1 Press CLOCK 2 Set the time 3 Confirm Basic operation 1 Select the desired mode HEAT COOL AUTO FAN DRY 2 Start/stop the operation POWER/DEICE • Please note that the OFF indication on to start. Is 3 Select the desired temperature • Selection range: 16 °C ~ 30 °C (Not applicable for FAN mode). [. . . ] Do not open window or door for long time during COOL/DRY mode operation. Prevent water leakage by ensuring drainage pipe is: - Connected properly, - Kept clear of gutters and containers, or - Not immersed in water After a long period of use or use with any combustible equipment, aerate the room regularly. After a long period of use, make sure the installation rack does not deteriorate to prevent the unit from falling down. remote control Do not use rechargeable (Ni-Cd) batteries. To prevent malfunction or damage of the remote control: • Remove the batteries if the unit is not going to be used for a long period of time. € New batteries of the same type must be inserted following the polarity stated. CAUTION Indoor unit and outdoor unit Do not wash the indoor unit with water, benzine, thinner or scouring powder to avoid damage or corrosion at the unit. Power supply Do not disconnect the plug by pulling the cord to prevent electric shock. 5 How to use MODE To select operation mode HEAT - To enjoy warm air • Unit takes a while to warm up. The POWER indicator blinks during this operation. € Unit may stops warm air supply for deice. The deice indicator ON during this operation. COOL - To enjoy cool air • To reduce power consumption during COOL mode, use curtains to screen off sunlight and outdoor heat. DRY - To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. FAN - To circulate air in the room AUTO - For your convenience • During operation mode selection the POWER indicator blinks. € Unit selects operation mode every 10 minutes according to setting temperature and room temperature. Remote control receiver and indicator POWER/DEICE (Green/Blue) TIMER (Orange) Remote control display AUTO HEAT COOL DRY FAN FAN SPEED AIR SWING OFF/ON MODE TEMP AIR SWING FAN SPEED TIMER ON 1 2 SET 3 Press and hold for approximately 10 seconds to show temperature setting in °C or °F. Raise the front panel: • To use in AUTO mode, press the button once. € To use in COOL mode, press and hold the button until 1 beep is heard, then release. € To use in HEAT mode, press and hold the button until 1 beep is heard, then release. And press again until 2 beeps, then release. 6 AIR SWING To adjust vertical airflow direction To set the timer 2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset times. [. . . ] € Changes of temperature caused the expansion/ contraction of the unit. Check the following before calling for servicing. Symptom Check Operation in HEAT/COOL mode is not working • Set the temperature correctly. € Clear any obstruction at the air inlet and air outlet vents. [. . . ]