User manual PANASONIC CSCE9JKE

[. . . ] Do not attempt to repair the unit by yourself. Do not install the unit in a potentially explosive atmosphere. Do not wash the unit with water, benzene, thinner or scouring powder. Do not use for other purposes such as preservation of food. [. . . ] For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. Do not install the unit in oily and smoky areas. Press and hold until 1 beep is heard, then release. Press and hold until 1 beep is heard, then release. Press again until 2 beeps, then release. To turn ON or OFF the unit at a preset time. Please be aware of the OFF indication on the remote control display to prevent the unit from starting/ stopping improperly. Operating the unit within the recommended temperature could induce energy saving. Unit selects operation mode every 30 minutes according to temperature setting, outdoor and room temperature. During operation mode selection the power indicator blinks. [. . . ] Indoor fan stops occasionally during automatic · Airflow continues even after operation has · Extraction of remaining heat from the indoor unit (maximum 30 seconds). Operation is delayed a few minutes after · Power indicator blinks during operation and · The unit is in defrost mode, and the melted frost is drained from the the indoor fan is stopped. Indoor fan stops occasionally during heating · Power indicator blinks before the unit is · This is a preliminary step in preparation for the operation when the ON switched on. Certain fluorescent lights may interfere with signal transmitter. [. . . ]