User manual PANASONIC CS-E12GKEW

[. . . ] These symbols denote an actions that is COMPULSORY. INDOOR UNIT REMOTE CONTROL 6~7 8 9 TROUBLESHOOTING WARNING INFORMATION QUICK GUIDE BACK COVER NOTE The illustrations in this manual are for explanation purposes only and may differ from the actual unit. It is subjected to change without notice for future improvement. OPERATION CONDITION Use this air conditioner under the following temperature range Temperature (°F) COOLING HEATING Max. Indoor *DBT *WBT 89. 6 73. 4 60. 8 51. 8 86. 0 60. 8 Outdoor *DBT *WBT 109. 4 78. 8 60. 8 51. 8 75. 2 64. 4 5. 0 3. 2 INDOOR UNIT AND OUTDOOR UNIT This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Remove the batteries if the unit is not going to be used for a long period of time. New batteries of the same type must be inserted following the polarity stated to prevent malfunction of the remote control. Indoor Unit Remote Control Air Inlet Air Outlet Power Supply Outdoor Unit Air Inlet Air Outlet 3 Air Inlet MULTI AIR CONDITIONER SYSTEM Multi Split Outdoor Unit (CU-2E18JBK-1) DEFINITION Multi air conditioner systems save space by letting you connect multiple indoor units to a single outdoor unit. INDOOR UNIT · It is possible to operate the indoor units individually or simultaneously. The operation mode priority is given to the first unit that turned on. · During operation, heating and cooling mode could not be activated at the same time for different indoor unit. The power indicator blinks to indicate the indoor unit is standing by for different operation mode. Living room Multi Split Outdoor Unit Bedroom POWER SUPPLY Models Number CS-E9JKKW-1 / CU-E9JKK-1 CS-E12JKKW-1 / CU-E12JKK-1 CS-E18JKK-1 / CU-E18JKK-1 CS-E12GKEW-1 / CU-E22JKK-1 CS-E9JKKW-1, CS-E9JKKW-1 / CU-2E18JBK-1 CS-E9JKKW-1, CS-E12JKKW-1 / CU-2E18JBK-1 CS-E12JKKW-1, CS-E12JKKW-1 / CU-2E18JBK-1 Time Delay Circuit Breaker 15 Amps 15 Amps 20 Amps 25 Amps 25 Amps Rated Volts Single Split System 208/230V Multi Split System 4 208/230V INDOOR UNIT · Switch off the power supply before cleaning. · Do not touch the aluminium fin, sharp parts may cause injury. CAUTION CLEANING INSTRUCTIONS · Do not use benzene, thinner or scouring powder. · Use only soap ( pH7) or neutral household detergent. · Do not use water hotter than 104°F. HINT · To ensure optimal performance of the unit, cleaning maintenance has to be carried out at regular intervals. Dirty unit may cause a malfunction and you may see error code "H99". Please consult authorized dealer. 2 4 1 7 9 8 3 5 6 1 INDOOR UNIT 7 AUTO OFF/ON BUTTON · Wipe the unit gently with a soft, dry cloth. 2 TO SET TEMPERATURE · Selection range : 60°F ~ 86°F. · Operating the unit within the recommended temperature could induce energy saving. DRY mode : 2°F ~ 4°F lower than room temperature. 3 TO SELECT OPERATION MODE AUTO HEAT COOL DRY Remote Control display AUTO mode - For your convenience · During operation mode selection the power indicator blinks. · Unit selects operation mode every 30 minutes according to temperature setting, outdoor and room temperature (For Single Split System). · Unit selects operation mode every 3 hours according to temperature setting, outdoor and room temperature (For Multi Split System). HEAT mode - To enjoy warm air · Unit takes a while to warm up. The power indicator blinks during this operation. COOL mode - To enjoy cool air · Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. FAN SPEED AIR SWING OFF/O MODE N 1 FAN SP EED 3 TEMP QUIET AIR SW IN G 2 4 5 8 7 TIMER ON POWER FUL 9 10 13 SET 1 OFF CANCE L AC SET CH ECK CL OCK RESET RC 2 3 11 12 6 E9JKKW-1, E12JKKW-1 7 TO ENJOY QUIET OPERATION TO SET THE TIMER · To turn ON or OFF the unit at a preset time. ON 1 2 · This operation reduces airflow noise. 8 TO REACH TEMPERATURE QUICKLY · Single Split System: This operation stops automatically after 20 minutes. [. . . ] Operation is delayed a few minutes after restart. Power indicator blinks during HEAT mode with no warm air supply (and louver is closed). Indoor fan stops occasionally during heating operation. Power indicator blinks before the unit is switched on. [. . . ]