User manual PANASONIC CSHE9PKE1

[. . . ] Before operating the unit, please read these operating instructions thoroughly and keep them for future reference. The included Installation Instructions should be kept and read by the installer before installation. Remote control is packaged in the indoor unit and removed by the installer before installation. ACXF55-05530 Dansk Suomi Norsk Svenska English Provide maximum comfort and optimise energy saving ECONAVI The sunlight sensor detects the sunlight intensity and helps control heating/cooling temperatures to provide optimum comfort. [. . . ] CAUTION Indoor unit and outdoor unit Do not wash the indoor unit with water, benzine, thinner or scouring powder to avoid damage or corrosion at the unit. Power supply Do not disconnect the plug by pulling the cord to prevent electric shock. Safety precautions English 5 How to use (Green/Blue) (Orange) ECONAVI (Green) (Orange) (Orange) (Green) Indicator To optimise energy saving MODE To select operation mode To enjoy warm air To enjoy cool air To dehumidify the environment To circulate air in the room For your convenience Remote control display Sunlight sensor and remote control receiver HEAT COOL DRY FAN AUTO +8/10°C HEAT To use maintenance heating Press and hold for approximately 10 seconds to show temperature setting in °C or °F. € This operation overwrite the operation mode and MODE could be cancelled by pressing • Defrost operation at outdoor unit will result in sudden cold air from indoor unit. 4˚F To switch between powerful & quiet QUIET NORMAL POWERFUL POWERFUL: To reach temperature quickly POWERFUL To select fan speed (Remote control display) • This operation stops automatically after 20 minutes. qUIET: To enjoy quiet operation QUIET • This operation reduces airflow noise. € For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. € In HEAT mode, if manual fan speed caused discomfort, set the fan speed to AUTO or lower the fan speed. auto OFF/ON button Use when remote control is misplaced or a malfunction occurs. Raise the front panel: • To use in AUTO mode, press the button once. € To use in COOL mode, press and hold the button until 1 beep is heard, then release. € To use in HEAT mode, press and hold the button until 1 beep is heard, then release. And press again until 2 beeps, then release. To set the timer AIR SWING To adjust airflow direction 2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset times. 1 TIMER ON 1 2 (Remote control display) 2 3 SET 3 2 Set the time 2 3 Confirm SET TIMER • To cancel ON or OFF timer, press or OFF to select respective or then press CANCEL. € If timer is cancelled manually or due to power failure, you can restore the timer again by ON pressing or OFF to select respective or SET then press . • The nearest timer setting will be displayed and will activate in sequence. € When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time. € Timer operation is based on the clock set in the remote control and repeats daily once set. for clock setting , please refer to Quick guide. ON Note ECONAVI POWERFUL/ QUIET ECONAVI POWERFUL/ QUIET , • Can be activated in all modes and can be cancelled by pressing the respective button again. , • Cannot be selected at the same time. [. . . ] For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] Pb 11 Troubleshooting / Information These symbols are only valid in the European Union. [. . . ]