User manual PANASONIC CS-MRE7PKE

[. . . ] € Operating the unit within the recommended temperature may save energy. € To dim or restore the unit’s indicator brightness, press and hold for 5 seconds. € Use remote control within 8 m from the remote control receiver of the indoor unit. TEMP AIR SWING TIMER ON 1 2 SET 3 OFF CANCEL AC RC SET CHECK CLOCK RESET 8m The illustrations in this manual are for explanation purposes only and may differ from the actual unit. [. . . ] Do not install the unit in oily and smoky areas to prevent damage to the unit. Do not dismantle the unit for cleaning purpose to avoid injury. Do not step onto an unstable bench when cleaning the unit to avoid injury. Do not place a vase or water container on the unit. Water may enter the unit and degrade the insulation. Do not open window or door for long time during COOL/DRY mode operation. Prevent water leakage by ensuring drainage pipe is: - Connected properly, - Kept clear of gutters and containers, or - Not immersed in water After a long period of use or use with any combustible equipment, aerate the room regularly. After a long period of use, make sure the installation rack does not deteriorate to prevent the unit from falling down. English Safety precautions Remote control Do not use rechargeable (Ni-Cd) batteries. To prevent malfunction or damage of the remote control: • Remove the batteries if the unit is not going to be used for a long period of time. € New batteries of the same type must be inserted following the polarity stated. CAUTION Indoor unit and outdoor unit Do not wash the indoor unit with water, benzine, thinner or scouring powder to avoid damage or corrosion at the unit. Power supply Do not disconnect the plug by pulling the cord to prevent electric shock. Indb 5 11/23/2012 3:51:47 PM How to use MODE To select operation mode AUTO mode - For your convenience • During operation mode selection the power indicator blinks. € Unit selects operation mode every 3 hours according to setting temperature, outdoor temperature and room temperature. HEAT mode - To enjoy warm air • Unit takes a while to warm up. The power indicator blinks during this operation. COOL mode - To enjoy cool air • To reduce power consumption during COOL mode, use curtains to screen off sunlight and outdoor heat. DRY mode - To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. Remote control receiver and indicator POWER (Green) TIMER (Orange) Remote control display AUTO HEAT COOL DRY FAN SPEED AIR SWING OFF/ON MODE FAN SPEED TEMP AIR SWING Press and hold for approximately 10 seconds to show temperature setting in °C or °F. Raise the front panel: • To use in AUTO mode, press the button once. € To use in COOL mode, press and hold the button until 1 beep is heard, then release. [. . . ] The unit stops and the TIMER indicator blinks. use remote control to retrieve error code. 1 Press for 5 seconds TIMER ON 1 2 SET 3 2 Press until you hear beep sound, then write down the error code 3 Press for 5 seconds to quit checking OFF CANCEL AC RC SET CHECK CLOCK RESET 4 Turn the unit off and reveal the error code to authorised dealer • For certain errors, you may restart the unit for limited operation with 4 beeps when operation starts. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. [. . . ]