User manual PANASONIC CU-C7HKD

[. . . ] Please consult an authorized dealer or specialist for the installation work. · Do not insert your fingers or other objects into the unit. · Do not attempt to repair the unit by yourself. Air inlet Indoor Unit · Do not install the unit in a potentially explosive atmosphere. · Do not wash the unit with water, benzene, thinner or scouring powder. [. . . ] Mode Auto Cooling INDICATOR dis Horizontal airflow direction louver · Manually Vertical airflow adjustable. direction louver · Do not adjust by hand. (Green) (Orange) (Orange) (Orange) (Blue) 8m tan ce s: Receiver TO TURN ON OR OFF THE UNIT · Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. TO SET TEMPERATURE Remote control display Ma xim um · For cool and dry modes, the range of temperature for selection is 16°C ~ 30°C. · Operating the unit within the recommended temperature could induce energy saving. DRY mode : 1°C ~ 2°C lower than room temperature. TO SELECT OPERATION MODE AUTO mode - For your convenience · Unit selects the operation mode according to the room temperature. · Once auto mode is selected, the unit will operate at the standard setting temperature. · To change the standard setting temperature, press for "HI" or for "LO". Room Operation Standard setting temperature mode temperature 23°C & above Cool 25°C Below 23°C Dry 22°C HI (+2°C) 27°C 24°C LO (-2°C) 23°C 20°C COOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. 4 · To turn ON or OFF the unit at a preset time. · For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. TO ADJUST VERTICAL AIRFLOW DIRECTION (5 OPTIONS) Select ON or OFF timer. or then · To cancel ON or OFF timer, press · Keeps the room ventilated. · If AUTO is set, the louvers swing up/down automatically. TO ENJOY CLEAN & FRESH AIR · Generates negative ions to produce fresh air effect and attract dust which will then be captured at the positively charged e-ion filters. TO MONITOR AIR QUALITY · Patrol sensor detects air quality. · When air quality is at dirty level, e-ion operation will start automatically. QUITE POWERFUL press . · When ON Timer is set, the unit may start earlier (up to 15 minutes) before the actual set time in order to achieve the desired temperature on time. · Timer operation is based on the clock set in the remote control and repeats daily once set. For clock setting, please refer to Remote Control Preparation at back cover. · If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is resumed) by pressing . Indicator Air Quality Blue Clean Orange Moderate Red Dirty NORMAL OPTIONAL SETTINGS Patrol starts automatically with the unit switched on with . TO ENJOY QUIET ENVIRONMENT · This operation reduces airflow noise. TO ACHIEVE TEMPERATURE QUICKLY · This operation will stop automatically after 15 minutes. Press and hold for 5 seconds, then release to disable or restore this setting. Press and hold for 5 seconds to dim or restore the unit's indicator brightness. Press and hold for approximately 10 seconds to show temperature setting in °C or °F. [. . . ] Indoor fan stops occasionally during automatic · This helps to remove the surrounding odours. Operation is delayed a few minutes after · The delay is a protection to the unit's compressor. · Condensation or evaporation occurs on pipes. · The timer setting repeats daily once set. [. . . ]