User manual PANASONIC CU-E12PB4EA

[. . . ] sET 3 OFF CANCEL AC RC SET CHECK CLOCK RESET 3 Select the desired temperature • Selection range: 16 °C ~ 30 °C. € Operating the unit within the recommended temperature may save energy. € To dim or restore the unit’s indicator brightness, press and hold for 5 seconds. € Use remote control within 8 m from the remote control receiver of the indoor unit. [. . . ] Do not step onto an unstable bench when cleaning the unit to avoid injury. Do not place a vase or water container on the unit. Water may enter the unit and degrade the insulation. Do not open window or door for long time during COOL/DRY mode operation. Prevent water leakage by ensuring drainage pipe is: - Connected properly, - Kept clear of gutters and containers, or - Not immersed in water After a long period of use or use with any combustible equipment, aerate the room regularly. After a long period of use, make sure the installation rack does not deteriorate to prevent the unit from falling down. remote control Do not use rechargeable (Ni-Cd) batteries. To prevent malfunction or damage of the remote control: • Remove the batteries if the unit is not going to be used for a long period of time. € New batteries of the same type must be inserted following the polarity stated. CAUTION Indoor unit and outdoor unit Do not wash the indoor unit with water, benzine, thinner or scouring powder to avoid damage or corrosion at the unit. Indd 5 Process Black 17/04/2013 11:15:38 Safety precautions English 5 How to use MODE Single Multi Single split system Multi split system To select operation mode Remote control receiver AUTO - For your convenience • During operation mode selection the POWER indicator blinks. € Unit selects operation mode every 10 minutes according to setting temperature and room temperature. HEAT - To enjoy warm air • Unit takes a while to warm up. The POWER indicator blinks during this operation. COOL - To enjoy cool air • To reduce power consumption during COOL mode, use curtains to screen off sunlight and outdoor heat. DRY - To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. CL OS E AIR SWI TIM ER ER POW EN NG OFF OP /ON CL OS E OP EN Control Panel POWER (Green) TIMER (Orange) POWERFUL (Orange) QUIET (Orange) Remote control display AUTO AIR SWING (Orange) POWERFUL/ QUIET To switch between powerful & quiet QUIET NORMAL AUTO HEAT COOL DRY FAN SPEED AIR SWING POWERFUL OFF/ON POWERFUL: To reach temperature quickly POWERFUL Single Multi MODE • This operation stops automatically after 20 minutes. € Press the button again or turn OFF the unit to stop this operation. TEMP AIR SWING POWERFUL/ QUIET FAN SPEED TIMER ON 1 2 SET 3 Press and hold for approximately 10 seconds to show temperature setting in °C or °F. SET CHECK CLOCK RESET Can be activated in all modes and can be cancelled by pressing the respective button again. Press the button once to use in AUTO mode. Press and hold the button until you hear 1 beep, then release to use in forced COOL mode. [. . . ] For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. [. . . ]