User manual PANASONIC CU-E18HKEA

[. . . ] · Do not wash the unit with water, benzene, thinner or scouring powder. · Do not use for other purposes such as preservation of food. · Do not use any combustible equipment in front of the airflow outlet. · Do not expose directly to cold air for a long period. [. . . ] Please contact your installer, dealer or local authority for more information. Penalties may also be applicable for incorrect disposal of waste products, in accordance with national legislation. *subject to the national law of each member state Information on Disposal in other countries outside the European Union This symbol is only valid in the European Union. If you wish to discard this product, please contact your installer, dealer or local authority and ask for the correct method of disposal. · Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. · Do not install the unit in oily and smoky areas. 3 ENGLISH PRODUCT OVERVIEW & OPERATIONS PRODUCT OVERVIEW & OPERATIONS Ionizer Do not touch during operation. Supersonic air purifying device Auto OFF/ON button · Used when remote control is misplaced or malfunction. Automatic Press and hold until you Force 2 hear one beep, then release. Press and Normal 3 hold until you hear two cooling beeps, then release. Press and Force 4 hold until you hear three heating beeps, then release. Press the button to turn off. Front panel POWERFUL QUIET TIMER POWER SUPER ION ALLERU-BUSTER INDICATOR Airflow direction louver · Do not adjust by hand. Air filter Receiver 10m imu md istan ces: (Green) (Orange) (Orange) (Green) (Green) (Blue) OFF/ON Max TO TURN ON OR OFF THE UNIT · Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. Remote control display AUTO HEAT COO L DRY ION TEMP TO SET TEMPERATURE FAN SPEE D AIR SWIN G MOD E QUIE POW OFF/O N ion · Selection range: 16°C ~ 30°C. · Operating the unit within the recommended temperature could induce energy saving. DRY mode : 1°C ~ 2°C lower than room temperature. MODE T ERFU L TEM P TO SELECT OPERATION MODE FAN S PEED TIME R ON 1 AIR S WING SET 2 3 CAN CEL AUTO mode - For your convenience · Unit selects operation mode every 30 minutes according to temperature setting, outdoor and room temperature. During operation mode selection the power indicator blinks. HEAT mode - To enjoy warm air · Unit takes a while to warm up. The power indicator blinks during this operation. COOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. OFF SET CHE CK CLO CK AC RES ET RC INVE RTE R 4 · To turn ON or OFF the unit at a preset time. ON · For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. TO ADJUST AIRFLOW DIRECTION (5 OPTIONS) 1 OFF 2 TIMER SET Select ON or OFF timer. Set the time. ON Confirm. or then · Keeps the room ventilated. [. . . ] · After 15 minutes of operation, it is normal to have the following temperature difference between air inlet and air outlet vents: Cooling: 8°C Heating: 14°C NON SERVICEABLE CRITERIAS TURN OFF POWER SUPPLY AND UNPLUG then CALL Authorized Distributor under the following conditions: · Abnormal noise during operation. Check if the circuit breaker is tripped. Certain fluorescent lights may interfere with signal transmitter. If the indicator is still blinking, please consult · · · · Noisy during operation. [. . . ]