User manual PANASONIC CU-E28QKE

[. . . ] Before operating the unit, read these operating instructions thoroughly and keep them for future reference. 52-61 F569455 Nederlands Italiano Deutsch Español Français CS-E28QKES CU-E28QKE English Provide maximum comfort, clean air and optimise energy saving ECONAVI and AUTO COMFORT Equipped with the human activity sensor, the air conditioner ensures to deliver cool or warm air to you, and keeps the room consistently comfortable with minimum energy consumption. Furthermore, the sunlight sensor detects the sunlight intensity and helps control heating/cooling temperatures to provide optimum comfort. See “To learn more” for details. [. . . ] € When vertical airflow direction is set to AUTO, it stops at lower position to avoid cold air contact. However, you can adjust the louver direction manually. MODE MILD DRY COOLING NANOE-G TEMP POWERFUL/ / AIR SWING QUIET FAN SPEED TIMER ON 1 2 SET 3 Press and hold for approximately 10 seconds to show temperature setting in °C or °F. POWERFUL/ QUIET OFF CANCEL AC RC To switch between powerful & quiet QUIET NORMAL SET CHECK CLOCK RESET POWERFUL POWERFUL: To reach temperature quickly POWERFUL FAN SPEED To select fan speed (Remote control display) • This operation stops automatically after 20 minutes. qUIET: To enjoy quiet operation QUIET • This operation reduces airflow noise. € For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. Press the button once to use in AUTO mode. Press and hold the button until you hear 1 beep, then release to use in forced COOL mode. Press and hold the button until you hear 2 beeps, then release to use in forced HEAT mode. AUTO COMFORT To maximise comfort To set the timer 2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset times. 1 TIMER ON 1 2 AUTO COMFORT NANOE-G To purify the air 2 3 SET 3 NANOE-G • Can be activated even when the unit is turned off. In this condition, the unit will operate as a fan with AUTO fan speed and louver swing. OFF CANCEL AC C NANOE-G POWER OFF • After the unit is turned off, the nanoe-G in-filter deactivation may activate up to 150 minutes. Turning on the unit cancels this operation. € To disable this operation in the future, press and NANOE-G hold until a short beep sound is heard. This will not disable the nanoe-G to purify the air. € To restore the nanoe-G in-filter deactivation, NANOE-G press and hold until a long beep sound is heard. Cancel 2 Set the time 2 3 Confirm SET TIMER • To cancel ON or OFF timer, press or OFF to select respective or then press CANCEL. € If timer is cancelled manually or due to power failure, you can restore the timer again by ON pressing or OFF to select respective or SET then press . • The nearest timer setting will be displayed and will activate in sequence. € When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time. € Timer operation is based on the clock set in the remote control and repeats daily once set. [. . . ] € Certain fluorescent lights may interfere with signal transmitter. NON SERVICEABLE CRITERIAS TURN OFF POWER SUPPLY AND UNPLUG then please consult authorised dealer under the following conditions: • Abnormal noise during operation. € Water/foreign particles have entered the remote control. The unit stops and the TIMER indicator blinks. [. . . ]