User manual PANASONIC CU-RE9HKE

[. . . ] If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Dust on the electric power plug should be periodically wiped with a dry cloth. This equipment must be earthed and strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD). Otherwise, it may cause electrical shock or fire in case of malfunction. [. . . ] For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. Do not install the unit in oily and smoky areas. Auto Press and hold until 1 beep Force 2 is heard, then release. Cooling Press and hold until you Force 3 hear double beep sound, Heating then release. Be careful not to insert your fingers into the unit to WARNING avoid injuring by cross-flow fan. Please be aware of the OFF indication on the remote control display to prevent the unit from starting / stopping improperly. tO SET TEmPERATURE · For heat, cool, and dry modes, the range of temperature for selection is 16°C ~ 30°C. Operating the unit within the recommended temperature could induce energy saving. During Automatic Operation, the operation mode will be selected automatically in accordance with the room temperature, outdoor air temperature and set temperature of remote control. The operation mode changes every half hour if necessary. cOOL mode - To enjoy cool air DRy mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. When you want the air conditioner to turn ON or OFF automatically. DELAy OFF-TImER For example, to stop the air conditioner 5 hours later. For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. The OFF-TIMER can only be set while the air-conditioner is in operation. DELAy ON-TImER For example, to start the air conditioner 2 hours later. [. . . ] Indoor fan stops occasionally during automatic · Operation is delayed a few minutes after · The unit operates automatically when power is · it is the Auto Restart function of the unit. Operation will be restarted resumed after a power failure. Automatically under the previous operation mode and airflow direction when power is resumed as the operation is not stopped by remote control. Power indicator blinks during operation and · The unit is in defrost mode, and the melted frost is drained from the the indoor fan is stopped. [. . . ]