User manual PANASONIC CU-TE9HKE5

[. . . ] Please consult an authorized dealer or specialist for the installation work. · Do not insert your fingers or other objects into the unit. · Do not attempt to repair the unit by yourself. Air inlet Indoor Unit · Do not install the unit in a potentially explosive atmosphere. · Do not wash the unit with water, benzene, thinner or scouring powder. [. . . ] Please contact your installer, dealer or local authority for more information. Penalties may also be applicable for incorrect disposal of waste products, in accordance with national legislation. *subject to the national law of each member state Information on Disposal in other countries outside the European Union This symbol is only valid in the European Union. If you wish to discard this product, please contact your installer, dealer or local authority and ask for the correct method of disposal. · Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. · Do not install the unit in oily and smoky areas. 3 ENGLISH PRODUCT OVERVIEW & OPERATIONS PRODUCT OVERVIEW & OPERATIONS Super alleru-buster filter Front panel (movable panel) Ionizer Do not touch during operation. Auto OFF/ON button · Used when remote control is misplaced or malfunction. Press and hold until 1 beep is heard, then release. Press and hold until 1 beep is heard, then release. Press again until 2 beeps, then release. INDICATOR Horizontal airflow direction louver · Manually adjustable. dis Mode Auto Cooling Heating Air filters Receiver 8m (Green) Ma xim um Vertical airflow direction louver · Do not adjust by hand. s: tan ce (Orange) (Blue) OFF/ON TO TURN ON OR OFF THE UNIT · Please be aware of the OFF indication on the remote control display to prevent the unit from starting / stopping improperly. Remote control display TO SET TEMPERATURE · Selection range: 16°C ~ 30°C. · Operating the unit within the recommended temperature could induce energy saving. DRY mode : 1°C ~ 2°C lower than room temperature. TEMP MODE OFF/ON TO SELECT OPERATION MODE MODE CLOCK 1 ON POWERFUL AIR SW ING QUIET FAN SPEED 3 SET 2 OFF TIMER CANCEL AUTO mode - For your convenience · Unit selects operation mode every 30 minutes according to temperature setting, outdoor and room temperature. During operation mode selection the power indicator blinks. HEAT mode - To enjoy warm air · For cold air prevention, air might not blow out immediately and power indicator blinks when operation starts. · Also operates in defrost mode (maximum 12 minutes) where by the power indicator blinks. The melted frost is drained at outdoor unit and indoor fan is stopped. COOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. MOVABLE PANEL · Opens for air intake when operation starts, and closes when operation stops. During this time, do not hold it as it may cause malfunction or breakdown. 4 · To turn ON or OFF the unit at a preset time. 1 2 · For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. AIR SWING ON OFF 3 SET TO ADJUST VERTICAL AIRFLOW DIRECTION (5 OPTIONS) Select ON or OFF timer. [. . . ] · (Display is dim or transmission signal is weak. ) · The unit does not work. · · The unit does not receive the signal from the · remote control. · Ion indicator on the indoor unit is blinking. · Press the dealer. The unit stops and the timer indicator blinks. 1 Press for 5 seconds. 2 Browse for respective error code, where "beep" sounds are heard. TEMP OFF/ON NOTE : · Press the "RESET" button to quit checking. Unit might be operated with limited function depending on error found. [. . . ]