User manual PANASONIC CU-UE9QKE

[. . . ] Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Please consult authorised dealer or specialist to clean the internal parts, repair, install, remove and reinstall the unit. improper installation and handling will cause leakage , electric shock or fire. [. . . ] Do not place a vase or water container on the unit. Water may enter the unit and degrade the insulation. Do not open window or door for long time during COOL/DRY mode operation. Prevent water leakage by ensuring drainage pipe is: - Connected properly, - Kept clear of gutters and containers, or - Not immersed in water After a long period of use or use with any combustible equipment, aerate the room regularly. After a long period of use, make sure the installation rack does not deteriorate to prevent the unit from falling down. English Български Português Italiano Español Safety precautions Français Remote control Do not use rechargeable (Ni-Cd) batteries. To prevent malfunction or damage of the remote control: • Remove the batteries if the unit is not going to be used for a long period of time. € New batteries of the same type must be inserted following the polarity stated. CAUTION Indoor unit and outdoor unit Do not wash the indoor unit with water, benzine, thinner or scouring powder to avoid damage or corrosion at the unit. Power supply Do not disconnect the plug by pulling the cord to prevent electric shock. 5 How to use MODE To select operation mode Remote control display Remote control receiver and indicator POWER (Green) TIMER AUTO mode - For your convenience • During operation mode selection the power indicator blinks. € Unit selects operation mode every 10 minutes according to setting temperature and room temperature. HEAT mode - To enjoy warm air • Unit takes a while to warm up. The power indicator blinks during this operation. COOL mode - To enjoy cool air • To reduce power consumption during COOL mode, use curtains to screen off sunlight and outdoor heat. DRY mode - To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. (Orange) AUTO HEAT COOL DRY FAN SPEED AIR SWING OFF/ON MODE TEMP AIR SWING Press and hold for approximately 10 seconds to show temperature setting in °C or °F. SET CHECK CLOCK RESET FAN SPEED To select fan speed (Remote control display) • For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. € To have low noise priority operation, select the lowest fan speed ( ). auto OFF/ON button Use when remote control is misplaced or a malfunction occurs. Raise the front panel: • To use in AUTO mode, press the button once. € To use in COOL mode, press and hold the button until 1 beep is heard, then release. [. . . ] The unit stops and the TIMER indicator blinks. € This may be due to damp smell emitted by the wall, carpet, furniture or clothing. Indoor fan stops occasionally during automatic • This helps to remove the surrounding odour. Airflow continues even after operation has • Extraction of remaining heat from the indoor unit stopped. [. . . ]