User manual PANASONIC CY-RC50U

[. . . ] Universal Rear-View Camera English Model CY-RC50KU Operating Instructions Please read these instructions (including "Limited Warranty" and "Customer Services Directory") carefully before using this product and keep this manual for future reference. Safety information Read the operating instructions for the unit and all other components of your car navigation system carefully before using the system. They contain instructions about how to use the system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual. This pictograph alerts you to the presence of important operating instructions. [. . . ] 5770 Ambler Drive, Mississauga, Ontario L4W 2T3 http://www. panasonic. ca © 2007 Matsushita Electric Industrial Co. , Ltd. YEFM285995 F0207-0 Printed in Japan Warning Observe the following warnings when installing. Use on a DC 12 V grounded vehicle. This system can only be used on a DC 12 V grounded vehicle. It cannot be used in DC 24 V and other battery system (large trucks, diesel vehicles for use in cold regions, etc. ). Use on such vehicles would cause fire and breakdown. Disconnect the battery terminal during performing any wiring or installation work. Wiring or installation work with the battery terminal connected could cause electric shock and injury from shorting. This system should be installed in a way so that operation of vehicle protective devices such as an air bag is not hindered. Should this system be installed in a vehicle with a protective device such as an air bag or an anti-theft system, check with the car manufacturer about operational cautions prior to attempting installation and perform the installation in a safe and proper manner. Improper removal of the battery may result in a malfunction of a device or possibly death. Never use the security parts of the vehicle for mounting or grounding the system. Use of the bolts or nuts of security parts (steering, brake systems, fuel tank etc. ) can cause brake failure, fire, or other accidents. Check positions of pipes, tanks, electric wirings in the vehicle when mounting. Never interfere with or touch pipes, tanks, or electric wirings when opening holes in the vehicle body for installation. Check that the rubber water seals where the cord enters the vehicle are parallel to the rubber gasket where they are in contact. Do not display a direct view of the sun for long periods A burned image could remain on the screen. Do not use a cellular telephone or wireless equipment close to the system Screen noise and malfunctions could result. You are advised to use cellular telephone or wireless equipment away from this system. Disclaimers Any repairs to breakdowns or damage caused by fire, earthquake, third-party action, other accident, actions of the user, whether by accident or design, incorrect operation or usage under other abnormal conditions will, as a rule, require payment of repair fees. Not guaranteed when equipped in a commercial-use vehicle (buses, trucks, taxis, goods vehicles etc. ). Product servicing If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized Panasonic Servicenter. The product should be serviced only by a qualified technician. Replacing the Fuse Use fuses of the same specified rating (1 A). Using different substitutes or fuses with higher rating, or connecting the product directly without a fuse, could cause fire or damage to this unit. If the replacement of the fuse fails, consult your nearest authorized Panasonic Servicenter for service. Maintenance Caution on cleaning Do not wipe with volatile chemicals, such as alcohol, benzine, thinners and gasoline. These can cause deformation, deterioration and breakage. Do not wipe with cleaners that contain abrasive particles, as they leave scratches. [. . . ] When the air temperature is low, use the vehicle's interior heater or defogger, or a dryer, to warm the bonding area. Dirt and moisture on the bonding surface reduce bond strength and could cause the camera to fall off. After mounting the camera, do not expose it to rain or other water, pull it or subject it to strong forces for 24 hours. Note: The camera cannot be affixed to painted or glass surfaces which have been treated with fluoroplastics (treatments which shed water droplets, mud etc. ), or to re-painted surfaces. Rear view camera control unit Before mounting Wipe away all oil and dirt etc. from the mounting surface. Mounting on carpet etc. Rear view camera control unit Mounting on hard surfaces (floor etc. ) Rear view camera control unit Velcro tape Double-sided tape Note: Do not mount the control unit in the following locations, which could cause breakdowns. [. . . ]